Electronics Forum | Mon Feb 22 15:44:42 EST 2010 | remullis
Just bought a used machine and everything was working fine and now the camera will not initialize. Powered down completely and rebooted, same thing. I powered down again moved camera to center of axis, it moves to the lower right hand corner which I
Electronics Forum | Sat Aug 21 15:02:32 EDT 2010 | jry74
I have a pcb with 750 plated through holes that get Holtite sockets inserted into them. I have a method of pressing in 10 sockets at a time. However, when we are done, the board has bad warpage on the X and Y axis. Does anyone out there have any t
Electronics Forum | Mon Oct 18 16:36:14 EDT 2010 | sbabos
Hi Jacki, My name is Sandor and we are DAGE representative in Romania. Could you please re-send me your requirement by e-mail? And I will help you to find the right loaction where you can check your board. my e-mail: sbabos@quiptech.com Thank you i
Electronics Forum | Fri Nov 26 15:19:53 EST 2010 | mtech88
I Just got a Mydata M9 machine, It was working at the beginning. And now the Z-axis always come up a "out of limit" problem when machine is starting up. can any one help? or come in my factory to cal. the machine for us. We are in Los Angeles, CA.
Electronics Forum | Fri Jan 14 17:03:17 EST 2011 | tombstonesmt
We are currently running a new product with some very tight tolerances while depaneling. We are using a table top 3 axis robot w/ a drill. My question is what is the min/max distance between a component and the edge of the board? I'm having a hard ti
Electronics Forum | Sun Dec 04 10:40:23 EST 2011 | bobpan
Do you have the motor power turned on? It is next to the main power breaker (front panel of machine). Are all the covers down? Are the side covers pushed all the way in? What is the led status of your driver cards? They should be all green with no re
Electronics Forum | Thu Apr 12 17:49:35 EDT 2012 | rodrigo
I've done the Fuji flush. It does the same thing. We can not load proper again because it does not communicate with either the F4G or MCS/30. I was able to boot into mechanical mode at one point but now I can not do that either. This thing is drivi
Electronics Forum | Wed Jun 27 13:38:56 EDT 2012 | upguy
Thanks for the information and insights. Our booster is probably getting too hot, even with AC. There is bouncing when we trim component locations. Every so often, while trimming component locations, the x-axis will start to slowly move away (by i
Electronics Forum | Mon Sep 10 12:18:05 EDT 2012 | benreben
Hi, what's the feeding sensor error? the sensor for cartrige or the sensor on cylinder up of feeder? manual is step mode? if you have the number of error at screen,i have the fuji error code help. in step mode the machine is very slowly,maybe the a
Electronics Forum | Tue Jan 08 16:25:00 EST 2013 | eduardo3mx
hello I need your help I have a machine mpm ultraprint3000 with the damaged hard drive I made a copy to the hard drive of another machine the same, but I have problems with the x-axis origin does not, either the track center, and the stencil wiper w
