Electronics Forum | Thu Feb 04 04:28:52 EST 2010 | mika
You don't by any chance have a s/w called Motion Control s/w? it's on 1-2 floppy diskettes and it will boot from it also. Normally only the UIC field engineers have/has? this. With this we can actually run each axis & valve or whatever independentl
Electronics Forum | Tue May 11 10:57:35 EDT 2010 | ehess
Having a problem where i have no drive on any axis. Machine powers up, but won't reset. I have 24VDC from PS6 and PS1, located in the upper drawer. I do not have 12VDC @ PS2 in lower drawer. troubleshooting guide says to check DPR in/out, which I
Electronics Forum | Fri May 28 01:47:05 EDT 2010 | jeffr
I have the part you need. The Yamaha Part number is K39-M7173-000. The same part is used on Philips machines using a different part number. This assembly is expensive because the motor is attached to a Harmonic Gearbox and encoder. I have a new unit
Electronics Forum | Tue Jun 01 08:42:08 EDT 2010 | rgduval
I'm randomly having some motor move errors, as well. If you swap your MOT board, and the problem continues, you're down to a couple of problems. Could be that the motor is getting ready to die on you. Could be an encoder problem. Or, could be som
Electronics Forum | Fri Sep 24 16:01:07 EDT 2010 | dougt
I remember this problem but can't remember exactly what the reason was. It might have been the wrong pullup resistor on the MEI interface board used for the home photo on the y axis. You are right, after a couple hours the machine would work fine.
Electronics Forum | Wed Oct 20 11:14:55 EDT 2010 | swag
I hope you're fixed by now but my advice is to pull all connectors from drivers and reseat. Also, reseat connectors in I/O area + I think there's some cards that relay power to various axis in this area. Reseat all connectors. From my experience,
Electronics Forum | Tue May 10 12:25:38 EDT 2011 | leemeyer
It does sound as if you may have an encoder problem. Have you cleaned the encoder glass ? A spec of grease or other matter on theis glass can cause problems. Be careful when cleaning because you do not want to break it. Clean the front of the encoder
Electronics Forum | Thu Nov 10 00:38:54 EST 2011 | tpappano
Hi Jeff, no problem, I'll just pop them out and make copies. I'm betting the upgrade will take care of these silly problems. The machine with the "newer" firmware just goes and goes without any issues other than replacing that R-axis servo a while
Electronics Forum | Tue Nov 01 09:36:41 EDT 2011 | emeto
THe question is - does that happen on all of your programs or just in one program? If it is just this particular board, it might be some softwaRE limit issue. If it happens on more programs it is a hardware issue and it could be one of the following:
Electronics Forum | Tue Nov 08 07:23:03 EST 2011 | leemeyer
Thanks Bobpan, A function 6 tells me that I have firmware ver IVC 3.05. I keep getting a motor error 4 "The Xand/or Y axis did not reach the commanded position within 500 msec." The battery was dead on this machine so the mod codes were lost. I en
