Electronics Forum | Tue Nov 30 11:51:58 EST 1999 | g cronin
i have a large job that has quite a few stand-up axial resistors on it and i am looking for a way to prep them does anyone know of: - a service that does this type of preforming, - a fairly inexpensive machine capable of stand-up preforming please
Electronics Forum | Tue Nov 30 12:05:24 EST 1999 | Wolfgang Busko
Hi, you could try "www.streckfuss.com". I can�t imagine what is meant by "fairly inexpensive". That kinda stuff you can get used, maybe someone does have one of these dustcollectors laying around. good luck Wolfgang
Electronics Forum | Tue Nov 30 18:20:02 EST 1999 | Brian W.
It is also possible to use standoffs to provide the board spacing. There are permanent types and washaway types. This eliminates the need for special prepping of components. The operator slides the bead over the lead prior to installation. I have
Electronics Forum | Tue Nov 30 17:00:26 EST 1999 | Dave F
Listed in the archive are suppliers of lead forming equipment. Most have equipment that can do the stand-ups you require. Yes you may be able to find this used. Yes you may be able to find someone with that machine near you who after you buy the t
Electronics Forum | Tue Feb 17 22:26:53 EST 1998 | Larry
I have a Universal 6241A axial lead sequencer. 60 station rotary head. 8222 Controler Insertion rates up to 8,000 components per hour. Asking $80,000 E-mail for more info. larrys@adepttech.com
Electronics Forum | Fri Aug 02 11:45:26 EDT 2013 | garyck
Need to pick between an inexpensive Manncorp manual axial lead former or the Manix unit. Any one have any experience with either of these two units?
Electronics Forum | Mon Aug 05 10:26:31 EDT 2013 | garyck
HRFT-301.
Electronics Forum | Thu Feb 19 00:14:21 EST 1998 | Larry
I made a mistake on the price. It's only $55,000. Priced for a quick sale, we need the floor space. | I have a Universal 6241A axial lead sequencer. | 60 station rotary head. | 8222 Controler | Insertion rates up to 8,000 components per hour. | Askin
Electronics Forum | Fri Oct 02 11:33:49 EDT 2009 | floydf
I've got a Universal axial machine with an 8221 controller on it. It stopped communicating to the monitor. Also, when I start it up the run light comes on for a second and then goes off. Does anyone have any ideas on where I can find information for
Electronics Forum | Fri Oct 02 12:57:13 EDT 2009 | dnebel
Looks like you'll need to reset the controller. That will require turning the Run/Halt swith to Halt and back to Run. That should put an @ prompt on the screen. There is a list of inputs you continue through to reinitiate, but I have forgotten the
.gif)
