Electronics Forum | Sat Apr 21 19:24:59 EDT 2007 | Frank
Remember the good old days when we would boycott the Olympics in Russia because they were the "Commy bad guys"? Now that China is hosting, are we going to boycott now? We are too weak to do something like that now. I certainly wish we would. Plus
Electronics Forum | Mon May 07 12:04:59 EDT 2007 | patrickbruneel
Jerry, If you�re sure your board has sufficient flux it must be that your slow flowing (single lambda) wave produces more oxides then the flux can handle. Due to the conveyer angle the front of the board usually has less flux then the back of the bo
Electronics Forum | Thu May 10 10:54:15 EDT 2007 | wavemasterlarry
pEte, Check out the arkives for this topics because we done have talked about his subject at different dates just on a different time form now. Common cents is another area that to be looking into when handling componets from going into you r build
Electronics Forum | Wed May 16 02:18:02 EDT 2007 | Frank
Dave's right, if it has been shown that you are getting questionable parts from the vender, then pre-inspect them before they hit the production floor. If they are fine from the vendor and you are sure they are getting bent during the feeding action
Electronics Forum | Wed May 16 13:40:19 EDT 2007 | slthomas
"I read a study a while back by IBM that showed too strong a vacuum would cause too much moisture to enter the bags." That's what the nitrogen is for. If you pull a vacuum w/o backfilling with something dry, like nitrogen, pretty soon the vacuum ove
Electronics Forum | Thu May 17 03:52:34 EDT 2007 | kevinjm
Hi lads, I have a problem with asequencer 2596. We had a power cut last week which cut power to the seq. The battery on the controller box was dead(now replaced), which meant the exec file got deleted from machine. Now I can't load it back up again.
Electronics Forum | Thu May 17 10:48:20 EDT 2007 | mgrimes
Kevin, As Steve mentioned, you could be running out of memory space - a few things to check: 1. What is the file size and how far does it get when loading the exec back on? Depending on this, you could be out of memory. 2. You may or may not need a
Electronics Forum | Tue May 29 15:10:30 EDT 2007 | realchunks
Hi Jerry, Sounds like the white stuff is flux. I doubt if 4 pcb mfgers could be undercuring all at once. Good point though. Since you changed washers and now have the problem - it's your new washer. Can you bring back the old one to make sure?
Electronics Forum | Sat Jun 02 13:57:30 EDT 2007 | rodrigo
Hi all, We have an MCS30 connected to a CP6 and CP4 smt machines. Every time we need to set up a job, the operator has to type the data at the MCS30 terminal. We already have this data in a Windows PC file. I saw a ethernet and several unused serial
Electronics Forum | Mon Jun 18 11:54:35 EDT 2007 | grantp
Hi, The problem seemed to be across multiple batches of boards, so I think they were made correctly, and we don't use a carrier in the reflow oven. However we just moved our equipment to the new factory yesterday, and connect and start turning on