Electronics Forum | Fri Jul 23 14:07:52 EDT 1999 | Carl J. Odle
We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that after a p
Electronics Forum | Fri Jul 23 09:17:30 EDT 1999 | Earl Moon
| Dear Jason, | Smart Sonic has over 500 stencil cleaners in operation around the world. The Smart Sonic Stencil Cleaning Process is the only cleaning process that is Certified Environmentally Safe by the Environmental Protection Agency (EPA) and ve
Electronics Forum | Fri Jul 23 12:47:20 EDT 1999 | Bill Schreiber
Dear Earl, At Smart Sonic, we have seen fiducial deterioration as a result of the epoxy not being water-safe. Unfortunately, many stencil manufacturers believe their customers are still cleaning with solvents and therefore use an epoxy that is solve
Electronics Forum | Tue Jul 27 17:12:11 EDT 1999 | Earl Moon
| Dear Earl, | At Smart Sonic, we have seen fiducial deterioration as a result of the epoxy not being water-safe. Unfortunately, many stencil manufacturers believe their customers are still cleaning with solvents and therefore use an epoxy that is s
Electronics Forum | Wed Jul 28 16:05:12 EDT 1999 | Rob Fischer
| | | Just go look at the thread on stencil cleaners started by Scott Davies in the March 1-15, 1999 achives if you want to see some juicy stuff...then make your mind up about vendor inputs. Pretty obvious if you ask me... | | | | | | -Steve Gregory
Electronics Forum | Wed Jul 21 20:52:52 EDT 1999 | Scott
| | I have pcb's in which i am experiencing warping. | | the boards are 12.8125" on a diagonal measurement. | | they are out approximatley .010". | | the boards are combination thru-hole,smt, they also have 3ounce copper.what is acceptable,and what i
Electronics Forum | Thu Jul 22 06:54:45 EDT 1999 | Earl Moon
| | | I have pcb's in which i am experiencing warping. | | | the boards are 12.8125" on a diagonal measurement. | | | they are out approximatley .010". | | | the boards are combination thru-hole,smt, they also have 3ounce copper.what is acceptable,an
Electronics Forum | Thu Jul 22 05:53:55 EDT 1999 | Wayne Bracy
| Oh dear forum participants, | | I left a good job (finished contract under tyrannical rule with style and grace?) in the city of Spokane. Am now in Wisconsin doing DFM of all things. Yeah, I snagged that job on our forum and can't wait. | | This
Electronics Forum | Wed Jul 21 01:24:06 EDT 1999 | Scott McKee
| I recently switched from solder paste in 500 gram jars to 500 gram tubes. I did this to try to limit the time the paste is exposed to the room environment. But we have a need to clean the stencil every 4 - 5 boards which means taking the bulk paste
Electronics Forum | Fri Jul 16 21:56:04 EDT 1999 | Jeff Sanchez
| | | I need a good chemical to remove the lacquer finish off of magnet wire. I know there are different kinds but I need one that really works. Any suggestions would be great. thanks in advance guys. | | | | | What is it you're trying to do? | | D