Electronics Forum | Sun Nov 06 16:10:25 EST 2016 | teslalab2
Hi! I have a Quad IVc pick and place that runs dos. The GUI computer is a compaq prolinea 4/33s. The hard drive went stupid mode and now wont respond. I have all of the data backed up. I tried transferring the files to a fairly modern hard drive (20g
Electronics Forum | Thu Dec 14 23:21:12 EST 2017 | jmelson
OK, I think you are right! The one brush I can get to looks fine, the other one is on the back, and there's no way to get to it without removing the motor. Even the front brush was VERY hard to get back in. But, there are rubber plugs that allow y
Electronics Forum | Wed Apr 11 07:46:00 EDT 2018 | stephenj37824
You are probably right. The Aimex III handles a larger board was my biggest draw. I will check and make sure the NXT III comes in a dual gantry configuration. Finally heard back from Juki after I basically told them if I didn't hear back they were o
Electronics Forum | Thu Mar 28 20:40:35 EDT 2019 | sarason
I built myself a reflow oven using an off the shelf 29l fan forced oven with digital controls. I then fully insulated the cavity around it with kiln fibreglass, and added a metal infill at the back as the back of the oven was just a metal sheet. Anyw
Electronics Forum | Tue Jun 18 23:29:02 EDT 2019 | SMTA-David
Hi, I have an older Samsung pick and place (CP-40LV model). During last few runs I have experienced several feeders with the clear plastic tape cover not peeling back to expose the next part. I manually pull back the tape and it runs for a while and
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Tue Dec 03 09:54:20 EST 2019 | davef
CURIOUS MINDS WANT TO KNOW Which processes are "front end" and which are "back end"? Why are they separated like that? Why are "front end" and "back end" processes usually done in separate plants? What are the high-value activities? Which activi
Electronics Forum | Sun Feb 09 18:20:24 EST 2020 | richardcargill
Does this only happen with certain feeders or certain components? We have a few regularly used components that experience the same problem ( Philips SMT machinery ) where the cover tape is just too sticky. Experience taught us which components will c
Electronics Forum | Fri Feb 21 10:50:00 EST 2020 | tomdegas
I am getting the following error on our MY9 during hardware initialization: F-MOT-MSEDYN HYDRA Z/156 Motor Timeout After the Theta test, The HYDRA head moves slowly all the way to the bottom and then moves slowly back up and the system fails initia
Electronics Forum | Thu May 21 23:18:22 EDT 2020 | gabriel1blue
After the closing down for a few weeks we encountered a problem with our old pick and place machine. It reset to Japanese but we were able to change it back to English. Not when we start the machine and try to get it back to origin we get a counter o