Electronics Forum | Thu Sep 08 09:41:51 EDT 2005 | PWH
If you do find your camera is bad, I think they are relatively easy to replace if you get a new one. I have done a 1.0 and 4.0 GSM camera replacements but not a PEC as of yet. If it's like the 1.0 and 2.6 and 4.0's, likely it is not tough but will
Electronics Forum | Sun Apr 23 09:04:36 EDT 2006 | kanna
Does anyone have any experience with these ovens > ? We are looking at purchasing a used > one. Anything in particular I should look at > when inspecting it ? > > Any comments good or bad > appreciated..... > > Thnx, Sr. i have one problem he
Electronics Forum | Wed Oct 12 11:08:12 EDT 2005 | Mike
Hly, The solder ball in your picture looks just like the countless BGA solder joints that I�ve produced over the past 8+ years. We've had a good number of these joints X-rayed, cross-sectioned, and thermally stressed. Some say that the stretched loo
Electronics Forum | Tue Feb 28 13:46:28 EST 2006 | slthomas
Assuming you're using DOM and shelf life to determine what's good and what's not, you just have to know 1)the rate at which you use it up, 2) how much shelf life is left, and 3) the rate that it goes bad when not refrigerated. From that you can tel
Electronics Forum | Fri Oct 28 09:44:11 EDT 2005 | PWH
I'm considering buying a UIC Advantis P&P machine. I'm worried about the huge, additional cost of new feeders. We've been running GSM's for years so we have tons of GSM vibe bases, tracks and feeders. UIC tells me that old pneumatic GSM feeders ca
Electronics Forum | Thu Nov 03 09:50:45 EST 2005 | slthomas
"Besides I did say they would do a job." I know you did....note I was responding to a previous poster. ;) I mutter something under my breath about our Quads daily. They reject simple parts randomly for no apparent reason, refuse to align some no ma
Electronics Forum | Tue Nov 01 18:00:07 EST 2005 | PWH
The front nozzle plate arm had a build-up of grease and material on the roller plate that is closest to the linear bearing. This material caused the nozzle plate to be lower than normal; therefore it was not able to push the nozzle all the way to th
Electronics Forum | Thu Nov 17 13:04:58 EST 2005 | tommyttr
AOI should be operated by an INSPECTOR! Inspectors do not operate assembly machines or automated assembly equipment, why would an operator run an Automated Inspection? Are your operators certified to IPC standards to make calls on bad solder joints o
Electronics Forum | Wed Nov 23 17:24:43 EST 2005 | adlsmt
With Jars you tend to mix used paste back in with new paste and there is also a lot of air in the jar. If you are high mix try using cartridges and putting the used paste in little ziplock baggies. You can rip the baggies open including tearing the s
Electronics Forum | Tue Nov 29 23:02:08 EST 2005 | fastek
It's the opinion of someone who makes a living dealing with issues such as service, support, equipment longevity on all platforms and has been doing this for over 20 years. This includes extensive travel to Korea and Asia in general to gather first h