Electronics Forum | Sun Jul 02 23:39:27 EDT 2017 | bentepcb
I found that some guys in the forum will raise a question and answer the question by themself, just intend to attract others attention, and then sell their products. There's nothing wrong with selling your product, but if you intend to promote your p
Electronics Forum | Wed Oct 13 08:37:49 EDT 2010 | denisp
we have a static problem with 0603 led when removing the plastic retainer from the tape and reel. same problem with the feeder causing reject and bad placement. is there someone having the same problem? and how to fix it. thank you
Electronics Forum | Tue Jul 13 14:25:57 EDT 1999 | Earl Moon
| | | | Hi, | | | | | | | | I need some urgent informations on stencil design guidelines on how to perform epoxy printing on 0603 and 0402 components. Could anyone help? ( Reflow process is not possible because of some other constriants) | | | | |
Electronics Forum | Wed Jul 14 21:34:16 EDT 1999 | karlin
| | | | | Hi, | | | | | | | | | | I need some urgent informations on stencil design guidelines on how to perform epoxy printing on 0603 and 0402 components. Could anyone help? ( Reflow process is not possible because of some other constriants) | |
Electronics Forum | Thu Jul 15 14:38:38 EDT 1999 | JohnW
| | | | | | Hi, | | | | | | | | | | | | I need some urgent informations on stencil design guidelines on how to perform epoxy printing on 0603 and 0402 components. Could anyone help? ( Reflow process is not possible because of some other constriants)
Electronics Forum | Mon Aug 15 18:42:53 EDT 2011 | bandjwet
Does anyone have experience in doing dye and pry analysis on PoPs? A customer wants to know whether or not the board level or device-device interconnect is the suspect. What other technique can anyone recommend? BWET
Electronics Forum | Tue Aug 16 07:51:16 EDT 2011 | a
C-SAM is a non-destructive alternative that a lot laboratories and chip manufacturers use. Dye and Pry would work I suppose although I have never done it in practice with PoP but it should be any different for PoP.
Electronics Forum | Tue Aug 16 09:37:58 EDT 2011 | blnorman
Dye and pry is frequently used on BGAs to determine if there is a crack at the board level or component level interconnect. C-SAM will show internal delaminations of components, not sure how well it would work with solder joint cracks. You can also
Electronics Forum | Fri Aug 19 02:16:40 EDT 2011 | ppcbs
In my opinion destructive methods went out with the stone age. At least they did at our company. We specialize in non-destructive defect analysis. We can determine where the failure is i.e. assembly process, fab defect, BGA defect or plating proce
Electronics Forum | Fri Aug 19 05:07:00 EDT 2011 | robertwillis
Its not a problem to do you just modify the procedure slightly for the smaller thinner parts. There some images and on my CD ROM and posters see http://www.packageonpackage.co.uk website I will also be doing a workshop at APEX and there is a webinar
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
winsouce.jpg)