Electronics Forum | Thu Jun 04 14:30:13 EDT 1998 | Igmar
I would appreciate any information concerning the wash and bake of blank Printed Circuit Boards before assembly. + Is it necessary to wash and bake PCB�s before assembly? + If any, what is the reason for wash and bake of PCB�s? + If any, what type of
Electronics Forum | Thu Feb 12 16:50:40 EST 1998 | Igmar
I would appreciate any information concerning the wash and bake of blank Printed Circuit Boards before assembly. + Is it necessary to wash and bake PCB�s before assembly? + If any, what is the reason for wash and bake of PCB�s? + If any, what type of
Electronics Forum | Thu Feb 12 17:21:07 EST 1998 | Justin Medernach
| I would appreciate any information concerning the wash and bake of blank Printed Circuit Boards | before assembly. | + Is it necessary to wash and bake PCB�s before assembly? | + If any, what is the reason for wash and bake of PCB�s? | + If any, wh
Electronics Forum | Thu Mar 13 01:42:58 EDT 2008 | Sean
Thanks Real Chunks and Davef...Yours input is valuable to me. My inputs towards your question asked below: Questions are: * Why did you tell us the following? "This BGA is installed with heatsink (with hook at both side of the heat sink) manually b
Electronics Forum | Wed Mar 12 07:33:40 EDT 2008 | callckq
Hi All, One PCBA failed test after went through the Shock Test(Vibration) and suspected to be BGA solder ball crack. We performed dye and pry and found PCB's pad lifted with red mark ink penetrate pad underneath, what does this mean? Can I say the
Electronics Forum | Wed Mar 12 23:00:10 EDT 2008 | davef
You can say: The pad was lifted after reflow and prior to the dye and pry failure analysis. When we see lifted pads, we think: * That's a good solder connection * Either it took a lot of force to lift that pad or the fabrication of the board in the
Electronics Forum | Wed Mar 05 03:43:58 EST 2003 | testing
Hi, Mike Thanks for the reply With your oracle system were you able to perfom SPC analysis? and if possible do you have any Material that may be helpful for me to get my system setup i.e. whether through Excel, Access, Oracle etc. + What are your
Electronics Forum | Thu Sep 20 07:18:42 EDT 2018 | proceng1
Has anyone else been experiencing this lately? We have had a rash of boards that come in properly vacuum sealed. We store them in the hot room until we are ready to build, and we get bubbles under the solder mask. We've had 4 different jobs, all di
Electronics Forum | Fri Jul 15 13:28:55 EDT 2005 | Brian
A process consists of much more than just thee machine. When developing a cause and effect diagram ffor the process, there are many parameters that fall outside the machine itself. There are Man, Machine, Methods, and Materials. Just monitoring th
Electronics Forum | Mon Jan 25 18:15:39 EST 1999 | Joe
Greetings, We are discussing what should and what should not be baked and vacuum packed. Should we just concentrate on the fine pitch packages and the bga's? What about those components which come on blister tape, should they get baked and re-packed
.png)