Electronics Forum: banks (Page 1 of 16)

Panasonic NPM-W Nozzle error

Electronics Forum | Wed Nov 14 16:03:08 EST 2018 | cbeneat

Wondering if anyone will have an idea on what we are experiencing with our Panasonic. When the machine goes to change nozzles,it errors out saying "Nozzle exist error(Rack) occurred,(R side)" There is nothing in the nozzle bank, actually replaced ban

GSM Calibration

Electronics Forum | Wed Jan 31 08:26:36 EST 2007 | geb

I think it might be the feeder banks, that is causing the problem. I've tried picking a SOT-23 component using head 2 spindles 1-4 from a rear feeder bank and it is picking off centre. Doing exactly the same, but putting the feeder in a front bank it

Juki 2080 rear feeder bank in lower position error

Electronics Forum | Mon Oct 08 14:48:54 EDT 2018 | tey422

Need help on how to fix or temporary fix to bypass the "Rear feeder bank in lower position" error for the Juki 2080 machine. Even replace with different feeder bank won't fix. Any suggestions?

GSM Calibration

Electronics Forum | Wed Jan 31 19:16:46 EST 2007 | mika

BTW GEB; When you put the feeder in the front bank did you pick the comps with Head #2 and from the feeder bank just opposite from the rear non working feeder bank? Did you make your feeder banks fixed or is it already that? It just hits me, if you

Isolating QFN Ground

Electronics Forum | Fri Mar 15 15:51:26 EDT 2013 | rway

Is this for something permanent? Where is the ground pad located (mid-bank, bank-end etc.)? What is the lead pitch? Are you looking on rerouting this pin some place else? Can you provide a picture of the pad in question?

Mydata My9

Electronics Forum | Thu Oct 17 14:15:31 EDT 2019 | tey422

Try to check if there any foreign objects drop on the tool bank first. Even a tiny passive part could prevent the proper function of "open" and "close" of the tool bank. That's something to check too but always overlooked.

Mydata My9

Electronics Forum | Fri Oct 18 16:26:54 EDT 2019 | mendezt6

Swap part method??? Are you meaning swap the tool banks? The tabs on the tool bank look good, but if it’s tweaked slightly that would be hard to tell. Sorry, I’m just an operator/programmer. The person that did all this stuff left suddenly.

Mydata My9

Electronics Forum | Mon Oct 21 11:25:16 EDT 2019 | mendezt6

It sits flush in the bank and twist fine. The open and close are the 2 tabs on the tool bank right? When it’s closed the tool is twisted so it can’t pull up and open is the opposite?

Mirtec Programming Discussion

Electronics Forum | Wed Mar 13 19:56:34 EDT 2013 | hegemon

It has been some time since I programmed a mirtec machine, but I think the technique would be to break the component into different banks of leads with unique locations. U25_Top, U25_Right, U25_LEft, etc... Use the centroid location to check presence

Machine won't change nozzles

Electronics Forum | Mon May 16 11:45:35 EDT 2005 | PWH

Agree with PDE. We have two GSM's and we get this error often. Palm down e-stop when you get this error message. Machine will drop nozzle bank down after doing some segment repairs. Open covers and make sure nozzles are seated in reference to ali

  1 2 3 4 5 6 7 8 9 10 Next

banks searches for Companies, Equipment, Machines, Suppliers & Information