Electronics Forum | Fri Jun 29 14:15:00 EDT 2001 | stefo
This is a question about complying with J-STD-001 solderability testing. Do any of you have your vendors certify that the components and PCB's that you buy from them comply with the solderabilty requirements spelled out in the -002 and -003, in lieu
Electronics Forum | Tue Mar 25 11:43:48 EDT 2014 | sara_pcb
It is Solder Mask on Bare copper, The land finish is HASL as per MIL-PRF-55110G which accepts trace of HASL as acceptable. Wetting is acceptable. regards, R.Saravanan
Electronics Forum | Mon May 21 17:32:23 EDT 2001 | davef
I said: "Our electronic circuit board fabricators seal the boards in moisture barrier bags [MBB]. We discontinued the use of desiccant bags in these MBB because of concerns about the desiccant releasing materials that would affect the solderability
Electronics Forum | Thu Sep 05 23:18:03 EDT 2013 | feiyangniao
There is a new toy I received today: a NeoDen TM-240A automatic desktop pick and place machine! I’ve kept my eyes on this baby for a quite a while, and finally decided to make a purchase last week. The shipping was very fast: DHL from China, a total
Electronics Forum | Wed Jan 12 13:42:19 EST 2011 | dwonch
Hi All, I'm hoping there is a PCB expert or two hanging around. We're having some solderability issue on our boards. The finish is ENIG but it doesn't seem to be related to the finish process itself. We did SEM and EDX analysis and found aluminum an
Electronics Forum | Wed Mar 12 07:33:40 EDT 2008 | callckq
Hi All, One PCBA failed test after went through the Shock Test(Vibration) and suspected to be BGA solder ball crack. We performed dye and pry and found PCB's pad lifted with red mark ink penetrate pad underneath, what does this mean? Can I say the
Electronics Forum | Wed Dec 20 04:43:36 EST 2006 | greg york
Any decent flux would volatise off with the heat of the wave unless absorbed into the solder mask. Test this by trying to clean in alcohol or common solvent aerosol, if it does not clean then it is probably Mineral Salts from solder mask fillers. Ano
Electronics Forum | Thu Feb 22 10:32:25 EST 2001 | CAL
SCOTT- We do solderability testing for the electronics industry using a Multicore and Kester Wetting Balance testers. The standards we test to is IPC J-STD 002 for components and J-STD 003 for PCBs. There is also a system called SERA we co-developed
Electronics Forum | Fri Mar 14 11:25:02 EDT 2008 | hegemon
ol' hege has got to agree with Chunks and Dave. Seems every time there is a problem, the finger is first pointed at the process. For my $.02 it doesn't matter if your process is 100% bulletproof, procurement will screw it up by finding a vendor that
Electronics Forum | Mon Jan 15 11:41:56 EST 2007 | davef
Questions are: * Does the component take solder when you dip it in the solder pot to test the solderability of the leads? * Can you get full barrel fill when wave soldering a bare board? * Is your flux reaching the top of the board through the hole b
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
winsouce.jpg)
