Electronics Forum | Tue Aug 13 06:36:42 EDT 2002 | pbarton
What Pana equipment? Regards, Pete Barton
Electronics Forum | Fri Aug 16 11:40:43 EDT 2002 | smter5903
What Pana equipment? > > Regards, > > Pete Barton I didn't get any more info from your companies! Is this hard to find stuff?
Electronics Forum | Tue Feb 12 05:47:29 EST 2002 | Roy Barton
To Dave F. Thanks for your comments. I should point out that I am not well versed in SMT, I am more of a thick film and chip man. However I will look into your leads. I will try and find out more about the Quad equipment. I am very wary in getting
Electronics Forum | Tue Jan 29 19:47:36 EST 2008 | davef
Bruce Barton: We're not intending to suggest that anyone is purposely leaving WS flux residue on the board after cleaning. Fact is, Arun isn't sure if the boards are completely clean. Arun said, "We haven't tested the substrate for cleanliness." Gi
Electronics Forum | Thu Sep 12 10:45:29 EDT 2002 | pbarton
We have used a laser cut stencil 0.15mm (0.006") thick with 0.3mm (0.012") square apertures radiused in the corners 0.06mm (0.0025") to aid paste release. This approach with the (type 3) paste we use has proven successful on thousands of devices plac
Electronics Forum | Wed Aug 01 09:36:17 EDT 2001 | Pete Barton
Jay, > > I agree with your assement and Chips on > the Quads. I once worked at a shop that had Quads > and DynaPerts(at the time) The perts were > slower(TIME) and required(EFFORT/PEOPLE) more > MAINTENANCE(more effort more people and more > re
Electronics Forum | Tue Dec 19 21:33:47 EST 2006 | davef
Job Agencies Adecco 6406 N. IH 35, #1202 Austin, TX 78752 512-794-2944 � tech360@adeccona.com http://www.adeccotechnical.co Aerotek (aka TEKsystems) 12331 Riata Trace Parkway, Bldg 3, #A200 Austin, TX 78727 512-249-4900 � http://www.teksystems.co
| 1 |
