Electronics Forum | Fri Jun 08 16:36:58 EDT 2012 | noid
KIC 24/7 has evolved into RPI. Not only will it give you virtual profiles, it also gives you DPMO and yield, based where each board lands in the process window. The good thing about this software, you can go back a year later and look up a specific
Electronics Forum | Fri Jun 22 06:31:08 EDT 2012 | grahamcooper22
Are you spray fluxing ? If so, check that you are getting flux onto the whole pcb uniformly.... That BLT flux is a water based material, are you getting rid of all the water in the preheat before you get to the wave ( can you hear any spitting as t
Electronics Forum | Mon Jul 02 07:41:08 EDT 2012 | jsolloway
I am going through the process of re-evaluating our AOI systems. Depending on the complexity of your assemblies, I would recommend Mirtec's, and aoi systems as the previous post suggests. Had a demo from them a month or so ago and for the price the
Electronics Forum | Fri Jul 06 10:45:02 EDT 2012 | ashworth14
In relation to question 2 the vacume on them is quite sensitive so as long as you bring it down slowly the component is almost sucked up off the PCB so you don't have to actually press it down on the the component, and i have never experienced any so
Electronics Forum | Mon Jul 16 07:10:09 EDT 2012 | mccabekev
I have found that Edding do an aerospace marker, which is water based and does not run with the conformal coating. However, this washes off prior to the coating so it is not much use. Looks like we are just going to have to put some clear tape over
Electronics Forum | Mon Jul 09 11:52:21 EDT 2012 | bobpan
Does it show the ANC in a position on the feeder base in the screen that has the nozzles/hole positions? When you go to optimize ...there is a screen that has something to do with registered ANC.....There could be something there that is incorrect. I
Electronics Forum | Mon Jul 09 18:29:19 EDT 2012 | btipcb
I have gotten to what I hope is the last step before I can start running product. However, I have and keep receiving an "Invalid Place Position X" error in three steps of the placement program. I have verified that the camera can indeed find these
Electronics Forum | Tue Jul 17 00:10:32 EDT 2012 | amitsindwani
Referring to IPC/JEDEC J-STD-033B.1 section 3.3.2.2 'The amount of desiccant used, per moisture barrier bag, shall be based on the bag surface area and WVTR in order to limit the interior relative humidity in the MBB to less than 10% at 25°C.' So wha
Electronics Forum | Mon Jul 16 13:54:53 EDT 2012 | markhoch
It's been a while since my MYDATA days, but let's give this a shot. Did you try putting the tool away and picking it back up? Make sure your Midas Head is cleaned and the tool is lubricated properly, then do a Center Base Leveling Calibration. (I t
Electronics Forum | Sun Aug 19 07:59:06 EDT 2012 | processman
Thanks for the replies guys. Interesting the one with the dryer in the air supply, will look into this. Sure some of our service guys lightly grease the O rings within the spindles, have been trying to get them away from this. Also interesting to h