Electronics Forum | Tue Aug 23 14:29:19 EDT 2005 | Shean Dalton
We have had positive experiences with our evaluations of Zestron Vigon SC200. To make the determination adequate to support your process application, the Vigon SC200 should be cross referenced to your specific adhesive, water soluble and no-clean pa
Electronics Forum | Thu Aug 25 09:09:41 EDT 2005 | stepheniii
I did a search for "DFM" and most of the posts were from the previous century. Is there a tool that is not too expensive that will check a board layout based on DFM criteria? I don't think there could be a good one to give the number of parts and spa
Electronics Forum | Tue Sep 06 09:20:50 EDT 2005 | Bob R.
We approached it the same way we select SnPb pastes. We started by doing coupon level tests to sort out the obvious "bad" pastes: SIR, wetting, solder balling, print quality, etc. That cut the field in half. From there we started to do assembly l
Electronics Forum | Fri Sep 23 09:25:46 EDT 2005 | Base
Hey Greg, As you already pointed out yourself: unless you can do away with covertape pickup-spools (or can figure out a way to empty them without loosing tension on the covertape) your feeders will not be suitable for several consecutive splices. S
Electronics Forum | Fri Sep 23 04:12:11 EDT 2005 | siverts
Installation/set up of the component shuttle is critical. The shuttle must be perfectly squared and leveled, since it has a 4 spindle pick/place head on it. This shuttle head can pick up to 4 comps. from the shuttle feeders (gang pick) and will deliv
Electronics Forum | Fri Sep 23 08:27:28 EDT 2005 | siverts
The 7 spindle Flex jet head, can only pick max 7 comps. from the GSM base machine in a single operation, not from the shuttle. The Flex jet head is faster in z-axis and will also use the OTHC (On The Head Camera) to inspect most of Your smaller comps
Electronics Forum | Mon Oct 17 00:00:46 EDT 2005 | grantp
Hi, I just found the invoice, and it was Japan Y 18,000,000, which currently translates to about US$156,564 based on the web translator I just tried. This price included front MFU and tray loader at rear and 9 nozzles. This price did not include
Electronics Forum | Wed Oct 19 07:44:33 EDT 2005 | davef
When a hole is drilled during board fabrication, it can transfer resin from the base material (eg, FR4 core or prepreg) to cover the exposed edge of conductive material in the wall of a drilled hole. This is called resin smear. Etchback is a control
Electronics Forum | Fri Oct 21 09:13:50 EDT 2005 | rlackey
Hi AJ, Depends on what machines you are running, how you run them, and if you have the spare components on feeders lined up ready to go. On a volume job using CP's using both feeder banks on change over I'd be upset if they stopped for more than a
Electronics Forum | Fri Oct 28 15:45:41 EDT 2005 | vickt
The older generation "GSM" feeders will work fine on the multifunction variations of the AdVantis Platform, but will not physically work on the Lightning based AC30L. The AC30L uses a 42v feeder interface, while the MF versions have both the new 42v
.gif)
