Electronics Forum | Wed Jun 27 11:58:42 EDT 2012 | cyber_wolf
Your tool tips are being damaged because the small x-motor is not engaging when the head is picking parts. When this happens the head overshoots and you bang the tips on the mag springs. Directly after a tip gets damaged go into the service program a
Electronics Forum | Sun Jul 01 10:29:46 EDT 2012 | anton99
Thanks dyoungquist and tech 1, Things have been crazy lately installing Mylabel and keeping up with customer demand. I have been looking into buying more reels for the high runners (caps, resistors, IC’s that we use a lot) and I think we have a shot
Electronics Forum | Wed Feb 27 08:31:02 EST 2013 | anton99
We are a OEM and growing pretty fast. The like the idea of setting up common components on the machine. It makes sense from a set up perspective. All of our set up is off line but the set up usually lasts longer than the SMT run so we have some spora
Electronics Forum | Thu Jul 05 11:26:08 EDT 2012 | cobham1
I need help with how long do I need to bake out double sided PCB's that have been cleaned. The units will not be reworked but instead will be moved on to hand stuffing. I have looked in IPC CH-65B and J-STD-033C. I get information for parts if I am r
Electronics Forum | Mon Jul 23 08:35:33 EDT 2012 | grahamcooper22
The lower the RH in the MBB the better for all moisture sensitive devices. Maintaining less then 5% will mean no parts of between 2a-5a MSL will need drying before use. The calculation uses 10% because it is a sensible amount of desiccant to use base
Electronics Forum | Mon Aug 27 08:22:39 EDT 2012 | rway
Dan_ems wrote, "I already build such a system with hardware and software from National Instruments. I think is the best solution because you can buy for the start only a Multimeter (DMM), a multiplexer and a software. Is very easy to do the programmi
Electronics Forum | Mon Aug 27 12:51:32 EDT 2012 | cobham1
I have run 0.031 boards. One of the things you may want to look at is the speed of the oven. With 14 zones you may be going to slow with the board which could be the reason your boards are starting to bow. You might also think about adding stiffners
Electronics Forum | Thu Aug 30 22:44:05 EDT 2012 | rway
I'm not saying that any unexplained failure is caused by ESD and I certainly am not promoting fear. I sleep very well at night (except after eating Mexican food, which can cause discharges as well). What I am saying is that ESD is a real threat and
Electronics Forum | Tue Oct 09 11:42:42 EDT 2012 | cyber_wolf
Actually the correct way to fix this is to carefully remove the belt on the rear of the machine that connects the left and right rail lead screws together. Square the rails then carefully re-install the belt *without turning either of the lead screws
Electronics Forum | Fri Oct 19 10:02:34 EDT 2012 | ericrr
First, why is there appears to be no marking on simple capacitors when there is a code for, yet there is markings on resistors? Attached is a interesting table, it came about after I spent hours and hours and hours looking on Internet from a 16 Volt
