Electronics Forum | Thu May 01 13:20:50 EDT 2014 | jimmyboz
Wow! What a thread! Emotions are running high. I will try to be less offensive. There should be a relationship between the vendor and customer, if not, there will be tension and disagreement. The goal, from my humble opinion is, "we" have to ins
Electronics Forum | Tue Jul 08 16:00:04 EDT 2014 | comatose
The boards are expensive because they are your product... covered in circuitry. A 2% scrap rate costs twice as much as a 1% scrap rate. Say the parts on your consumer electronics board cost $5. A machine that makes 99% good boards and 1% bad boards
Electronics Forum | Fri Aug 29 22:55:51 EDT 2014 | andrespena
I'm very sorry I did not see this reply earlier. It's been almost a month and I hope you get to read this! I really like your idea of a *personal* electronic circuit factory. You should try getting schools to buy it, because students will love the o
Electronics Forum | Thu Jul 24 03:33:30 EDT 2014 | edriansyah
Hi All.. I need your advice, when you send your boards to be analized by external lab, what kind of result would you expect from them? Do you expect them to find the root cause of the problem and give countermeasure of the problem? (this is what I e
Electronics Forum | Fri Sep 05 06:17:36 EDT 2014 | edriansyah
Hi, We have a problem with our BGA Pad. Our PWB manufacturer make the BGA Pad in irregular form. some big, some small. Please see the picture on attachment. BGA Detail BGA Pitch 0.5 mm BGA Ball 0.3 mm BGA Pad (big) 0.2 mm (as per gerber) BGA
Electronics Forum | Sat Sep 27 10:09:10 EDT 2014 | gascon5383
I have experience with an essemtec pick and place machine that I also had to deal with minimal training. I had no prior experience in pick and place programming and we had the technician for 3 days of training, but out of the package the machine didn
Electronics Forum | Sat Oct 18 22:41:54 EDT 2014 | pfifla1
Can't help you with the manual but do have some > tips: If it was shipped, it's possible someone > tied axis or blocked stuff for shipping. Look > for that. Look for bent sensor flags + go into > I/O and check to see all sensors you can find a
Electronics Forum | Thu Nov 13 17:47:00 EST 2014 | warwolf
could always use a potato? http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=9994Message56920 But seriously.. best idea is to stay away from any metal as the tin will likely dissolve and contaminate your solder pot.
Electronics Forum | Fri Nov 21 12:12:44 EST 2014 | joe98375
On average there are about 3 parts per board that get hand placed (x24 is 72 parts per panel). One of these parts is a big 1W resistor that cannot fit on our axial machine. We also have a Zener Diode that needs to be hand placed because its leads are
Electronics Forum | Tue Dec 23 09:13:12 EST 2014 | jeff701
I'm in a manufacturing environment with a very high mix of boards, and some low-mid volume. A "large" production run might consist of 100 boards. Volume: There are numerous boards that have a volume of 1-3 pieces. There are a few boards with an annua