Electronics Forum | Thu Jan 20 08:22:14 EST 2011 | padawanlinuxero
http://www.flickr.com/photos/94427924@N00/5372753378/sizes/m/in/photostream/
Electronics Forum | Fri Jan 21 11:00:56 EST 2011 | xps
Hi, in my experience, the humidity is trapped in the solder paste. Otherwise you can also try to : adjust preheat profile, and /or increase paste viscosity, and /or increase paste metal content (they are the most common causes).
Electronics Forum | Fri Jan 21 13:27:38 EST 2011 | mosborne1
Try baking your boards first to remove the moisture. Moisture and boards that have not been drilled properly will cause pin hole or blow holes in PTH. Also take a look the surface of the pads before printing. You maybe contaminating the surfaces of t
Electronics Forum | Sun May 24 11:16:14 EDT 2015 | jbservices
The ERR led is flashing on the TSX Nano PLC in our Heller 1088 due to a defective battery in PLC. Has any one got the PLC program I need to reload ? Or is there a way to restart PLC ? is program stored somewhere else in PLC ? many thanks john
Electronics Forum | Thu May 28 09:30:55 EDT 2015 | rgduval
Give Heller tech-support a call. They've always been awesome about supporting their equipment, even third-party purchases. +1-973-377-6800
Electronics Forum | Thu Jun 11 10:43:18 EDT 2015 | jbservices
hi robgd3 have tried in the UK with no luck, do you have a contact e mail for your guys in the USA ? many thanks john
Electronics Forum | Fri Jun 12 12:21:34 EDT 2015 | marcpeo
Hi John, Heller Europe--Joe Balackyi +44-777-55-11-008 Heller USA--+1-973-377-6800 (Dial 5 for Service) Hope this is helpful. Best, Marc
Electronics Forum | Fri Jun 12 14:30:53 EDT 2015 | rgduval
Heller USA is in New Jersey (east coast); so, GMT -5 to catch them when they're there!! Good luck!
Electronics Forum | Thu May 27 16:23:12 EDT 2004 | davef
Process Trials Procedures. Standard trials are often conducted on reflow ovens by production engineers during product assessment, machine approval or in process set-up. The following trials are also used by machine suppliers during equipment develop
Electronics Forum | Fri Apr 16 14:01:48 EDT 2010 | richardli
It could be the flux condensed in the oven. We plan to clean the vent and filter next week. Then we see if help. I just want to see if anybody has same problem in experience. Soldermask supplier told us the same white soldermask always change to a l