Electronics Forum | Tue Jun 15 22:31:06 EDT 2010 | Mag10
Depending on the how you plug the via, the void level can significantly affected. If you have via plugged from the bottom side; i.e. opposite side of the component, you will see alot of void due to entrapped air in the via hole. I found work best wh
Electronics Forum | Sat Jun 19 08:07:39 EDT 2010 | fortunetech
If you want to buy a Juki machine or any machine for that matter, then be ready with money in hand and you set the price you are willing to buy at today. In my experience alot of Asian Brokers want your best price up front, and then tell you it's too
Electronics Forum | Fri Sep 17 03:03:29 EDT 2010 | grahamcooper22
Hi Gani, looking at the HASL icture and the poor wetting of the solder over the pads I would imagine that the HASL coating is very thin on the pads and in actual fact isn't 'solder' but is tin /copper intemetallic and this has poor solderability. It
Electronics Forum | Sat Oct 02 15:26:59 EDT 2010 | rway
Possible, but difficult. What algorithm programs are you referring to? Mirtec and YesTech both utilize algorithms in their respective software. The algorithm is simply a series of instructions to perform the inspection. In this case, rules-based,
Electronics Forum | Mon Nov 01 16:22:47 EDT 2010 | jax
Who Cares... Mix Away! Although you should not mix different Solder Pastes' together in a container or on a stencil (Mostly due to the flux, although solder sphere size and shape could cause an issue), mixing solder brands or chemistries on a board
Electronics Forum | Tue Nov 09 20:52:34 EST 2010 | ppcbs
Yes, we have had this happen with certain solder masks over the years. Hot air gun is the best solution we can find if the oven doesn't do it. Back in the day when we had a vapor degreasor, freon based solvents would also remove the clouding. Let
Electronics Forum | Wed Nov 10 16:19:51 EST 2010 | davef
The 5 thou standoff of your SOIC is probably the minimum. We wouldn't be surprised to see 10 thou. With this, you could have maybe a 6 thou gap between printed solder paste and the bottom of the heat slug. So, you're expecting the rabbit ears of p
Electronics Forum | Fri Dec 03 12:16:58 EST 2010 | vmorina
Hi Jack, I haven't progressed that much on the reflow project.I'll be working on it in two weeks. Although, I have few vendors that I've been communicating for more info about vapor phase reflow ovens. See the following list: Wenesco Sintronex AICT
Electronics Forum | Wed Nov 17 05:20:38 EST 2010 | jlawson
Also please contact Rehm Thermal, they make best Vapor Phase systems in terms of cost of onwership - less galden usage than Asscon or IBL, have more controllable ramp rate control vs the other vendors also...use patented galden injection on demand an
Electronics Forum | Wed Dec 15 10:07:15 EST 2010 | rgduval
We provide PCB fabrication services, as well as contract assembly. Though, we source the PCB fab. If you're more interested in straight PCB fab houses....check out Vermont Circuits or Elektropak (VT Circuits is in Brattleboro, VT; Elektropak is in