Electronics Forum | Wed Jun 05 17:13:58 EDT 2002 | Yannick
Hello! I have a strage problem, we made some production with uBGA, BGA, 0201, 0805, and other type of component. We didn't put the uBGA and 0201 and BGA on the board at the end of the line we look a our solder joint and surprise the solder made a
Electronics Forum | Tue Mar 19 17:30:46 EST 2002 | rculpepp
Does anyone have or know of any published guidelines for BGA layout on PWB's so that they can be tested. Specifically using micro vias? If anyone has any input regarding other test considerations for BGA devices I'd like to hear from you as well. W
Electronics Forum | Wed Mar 20 07:57:30 EST 2002 | davef
Purchase: 7095 - Design and Assembly Process Implementation for BGA's Make every effort to distribute the test pads, because if you keep them massed at the ball, it would be a bijundo kick in the BGA rear section, when all of those pins released.
Electronics Forum | Sun Mar 01 14:51:55 EST 1998 | Vincenzo Longobardo
From several months I am investigation about the VOIDS PERSENCE and his important as reliability. One question now is : It is possible that on the BGA components the voids are already present into the balls, before the mounting on the pcb ? If you ha
Electronics Forum | Wed Sep 25 13:38:35 EDT 2002 | finepitch
Yannick, If we leave the 201 issue aside; have you checked where those BGA pads are connected to? Could those be power/ground balls connected to large (difficult to heat up) planes by any chance? Erhan
Electronics Forum | Thu Sep 07 03:57:39 EDT 2000 | Steven Cheung
Does anyone know of a freely-available document which discusses the main considerations of BGA assembly and inspection (x-ray?). l need to know about pad sizes and inspection standards and when to underfill and when not to etc.. l am looking at ass
Electronics Forum | Tue Jun 28 00:11:30 EDT 2016 | ricoloverde
Hi, new to the forum here. First Post! Ive been using a Samsung sm482 for about 2 years and recently got the heads up that we will be getting a project soon with a BGA chip. Im wondering if anyone on here uses the SM482 for BGA and if so, can offer
Electronics Forum | Wed Sep 25 06:56:16 EDT 2002 | CH
U may check your profile ramp rate. The flux may evporated and look like cold joint
Electronics Forum | Thu Jul 06 13:36:37 EDT 2006 | SWAG
We've had much trouble with flex circuits. As previously mentioned, you must have local fids for the board or the BGA itself (if panelized). Other troubles we experience are drilled holes for pinned connectors. Unless the PCB manufactur has some w
Electronics Forum | Tue Jul 11 11:18:06 EDT 2006 | dougs
Thats a good point SWAG, i'll look into that for the next run of these. cheers