Electronics Forum | Thu Oct 07 13:47:19 EDT 1999 | Doug Philbrick
| Our first article inspection after machine placement can take several hours depending on the complexity of the board. The operator visually checks the board against the drawing and bill of material. I'd be interested to hear if there are any other
Electronics Forum | Wed Oct 06 09:23:47 EDT 1999 | Wolfgang Busko
| I would like comments on how the industry handles 0402 parts, regarding identification. Since the parts are too small to be labeled, how can we accurately identify the parts and or values, either before or after assembly? | When the boards go to te
Electronics Forum | Wed Oct 06 00:26:04 EDT 1999 | Karlin
| Hi, | | Help! Could anyone help to enlighten me on this? | | Question: | | If I have a CSP/BGA package of size X by Y and the standoff gap between the component and PCB is Z, What is the maximum allowable Y/Z or X/Z that using a normal water cl
Electronics Forum | Wed Oct 06 08:41:42 EDT 1999 | Dave F
| | Hi, | | | | Help! Could anyone help to enlighten me on this? | | | | Question: | | | | If I have a CSP/BGA package of size X by Y and the standoff gap between the component and PCB is Z, What is the maximum allowable Y/Z or X/Z that using a n
Electronics Forum | Mon Sep 27 12:54:44 EDT 1999 | Earl Moon
| | | | Jackie's posting recently and responses to it got me to dondering. First, recollecting, we bought an IR rework station a couple million years ago. It had a IR source on a stand, a bunch of lenses, and Reynolds aluminum foil for shielding ne
Electronics Forum | Sat Sep 25 09:18:40 EDT 1999 | Steve E ( Fuji America )
| Question for you SMT guru's out there. | | What is the best way to support boards on Fuji's CP6 machine's x-y table...particularly for 2nd side SMT where the support side already has parts... I am toying around with the following methods: | | 1.
Electronics Forum | Wed Sep 22 09:25:42 EDT 1999 | Wolfgang Busko
| | i'm sure everyone has run into this at one point or another. I have a thin pcb .025 that is single up that has to be built on a pallet. does anyone have any tricks to the pallet design that will help to hold these boards down during the scree
Electronics Forum | Mon Sep 20 09:02:34 EDT 1999 | Wolfgang Busko
| Hi all, | | We have a little discussion here about the suitable flux for a certain process, as all of us are beginners we need your advice. | | We are producing VGA cards and mother boards for PC's all components to be wave soldered are TH, the S
Electronics Forum | Tue Sep 21 02:51:06 EDT 1999 | Mohammed saad
Thank you all for your help. about your question Wolfgang, I am using no-clean solder paste from Kester. Mohammed | | Hi all, | | | | We have a little discussion here about the suitable flux for a certain process, as all of us are beginners we ne
Electronics Forum | Tue Sep 14 10:54:37 EDT 1999 | Scott Davies
| Can anyone out there pls enlighten me on how to solve chip tombstone defects. | I am running a board with a lot of 0603 chip. i had fine the profile and the alignment, but it still happen randomly on the board itself. Is there any other way to sol