Electronics Forum | Thu Jan 19 11:04:08 EST 2006 | Mike Konrad
No, there are no issues with mixed lead / no-lead post-reflow cleaning. No-lead is a little harder to clean so be sure you use the appropriate parameters and cleaning chemical. The only potential issue is if you mix up the boards after cleaning,
Electronics Forum | Thu Feb 02 15:46:31 EST 2006 | MazinK
Hello Bobpan, Thanks for the reply. Please I need help, we have a quad machine here (QSV1 PLUS) and had problem Not INitilizing the machine, and keep give a message says, (( BUFFER FULL IN LINE 4), and FACTNET.CPP LINE 4. Quad saying could ne one of
Electronics Forum | Tue Feb 28 07:53:28 EST 2006 | amol_kane
some coatings are more forgiving to surface contaminations than others. best way to go about is select some coatings with the properties you need and then trial the boards to see any coating defects (like dewetting, pinholes, flaking etc) wiping wit
Electronics Forum | Fri Apr 21 23:28:54 EDT 2006 | SD
Sounds like you have a non-IQ system? If you can, get one! It makes life much easier. Costly, though! Anyway, as stated above, your best bet is to assign multiple boards to the same table top. If the two boards are 99% similar, use a full opti
Electronics Forum | Mon Apr 24 07:37:57 EDT 2006 | craig_83
We have the IQ system. The problem that I was having is that when I load one board to the other, I want to avoid the table top changeovers. So I figure if I can make certain tabletops to run certain boards the changeovers would be much less. I though
Electronics Forum | Thu Apr 20 14:33:18 EDT 2006 | dirk29
We had that problem with our printers we just drill and tap the top end of the stop and put a short screw in to allow us to adjust the top height of the stop and catch the board. Be careful not to make it to long or to could restrict the board from l
Electronics Forum | Wed Apr 26 03:32:29 EDT 2006 | saaitk
Hi all, Has anyone any experience they can share with regard to pad dissolution on PTH's on thick boards. We are using lead free SAC305 on both OSP and Immersion silver finishes and are experiencing difficulties when removing and replacing connector
Electronics Forum | Wed Jun 14 05:05:27 EDT 2006 | bk
Yes it's definately possible to have too much flux. You'll see a white residue film on the board. In the past we have had hipot issues cause of too much flux residue ,left on the boards. You defininately don't want to be using a no clean flux and sti
Electronics Forum | Fri Jun 30 14:55:38 EDT 2006 | xfuji
Is there anybody out there who encountered this error on their Siemens SMT machines? HEAD MAIN BOARD error "camera elimination cannot be activated" the board part number is 00330647-03 part name is PC BOARD FOR HEAD SP6 12 digital.Anybody who
Electronics Forum | Mon Jul 17 07:26:59 EDT 2006 | aj
Guys, I have an annoying problem on the above mentioned machine. Basically, when the machine loads a board it sits and waits at the down stop until it times out. All sensors on the rail system work fine in the IO's, aswell as the board stop sensor