Electronics Forum | Wed Aug 13 12:40:22 EDT 2008 | dphilbrick
easiest way is to weigh an empty board and then weigh a printed board, best to do 10 or so and take an average.
Electronics Forum | Wed Sep 03 12:29:47 EDT 2008 | omid_juve
That could lead to oxidation of the leads and > worsen solderability. It's much better to make > sure the components are handled properly and not > exposed to moisture. > > The reason for baking is > moisture in the body not in the leads. > > W
Electronics Forum | Wed Sep 03 12:34:43 EDT 2008 | stepheniii
I've seen where a new person comes on with some strange problem. Then someone else new comes on and says that the perfect solution is siplace boards. And for a while it seemed like Siplace boards were the solution to every problem. Or maybe they we
Electronics Forum | Tue Aug 26 13:28:50 EDT 2008 | qaman
I am new to the board so be gentle with me. There are standards such as IPC-610 for PCB assembly, IPC-600 for bare boards, etc. Is there a "standard" for electro-mechanical assembly? Is there an IPC standard or any other industry approved standard
Electronics Forum | Tue Sep 02 13:30:05 EDT 2008 | evtimov
I am new to the board so be gentle with me. > There are standards such as IPC-610 for PCB > assembly, IPC-600 for bare boards, etc. Is there > a "standard" for electro-mechanical assembly? Is > there an IPC standard or any other industry > appro
Electronics Forum | Wed Aug 27 07:13:05 EDT 2008 | eyalg
I need to solder SAC/HASL PC boards in a NON ROHS process (Tin Leaded solder paste and profile + Tin leaded components) Can I do that?? Regards, Eyal
Electronics Forum | Wed Aug 27 11:25:11 EDT 2008 | blnorman
We use immersion tin boards and ENIG with Sn63Pb37 with no problems. We did have to tweak the profile higher with ImmSn though.
Electronics Forum | Fri Sep 05 13:49:04 EDT 2008 | gregoryyork
Tell the board shop to increase the cure temp of the resist as it is undecured especially if you have waxy/greasy resiues on the board and a brown tar like substence in the solder wave itself. If undercured then solder will not flow off the resist pr
Electronics Forum | Mon Sep 29 14:47:15 EDT 2008 | davef
Let's narrow this down. Questions are: * Are you putting the proper amount of solder in the board with your stencil print process? * If you are putting the proper amount of solder in the board, where is the solder going? Pick one and then fill-in th
Electronics Forum | Wed Oct 01 07:51:13 EDT 2008 | mrmaint
We built tens of thousands of boards with transeivers on them with a no clean process.Never had any problems with the flux residue in relationship to board performance.
