Electronics Forum | Wed Jun 23 11:02:09 EDT 1999 | John Thorup
| | We are reflowing boards that have glop top components | mounted on them. Do glop tops have the same moisture | sensitivity as fine pitch? Should we be baking the boards | prior to reflow? | |If your glob tops are PBGAs, they are likely very mo
Electronics Forum | Fri May 21 15:50:41 EDT 1999 | John Thorup
We are running a number of boards with 8-10 25 mil PQFPs on board. Our process is mature with at least 3 years experiance and statistically few opens on the QFPs. Our beloved purchasing department has chased the almighty $ and changed FAB vendors
Electronics Forum | Tue May 25 09:19:00 EDT 1999 | Ricardo Lopes
| | Has anyone had any experience or data using vibration during the reflow process. | | We introduced a vibration device attached to the fixed rail on a Vitronics reflow oven. The reason was to prevent skewing on large PLCC devices. The process work
Electronics Forum | Thu May 20 15:13:50 EDT 1999 | JohnW
Folk's, One of my 'fellow' engineer's is brining in a new board that his customer has said shouldn't go over the wave..but he want's us to use intrusive reflow on a connector on the bottom side of the board..so since I was standing in the wrong pla
Electronics Forum | Wed May 05 20:22:33 EDT 1999 | ADRIANO FERNANDES
I would like to know if someone aleady have problems with Ceramic Capacitors SMD in In-Circuit Test (see below)and how did you solve this problems ? PROBLEMS 1 - Only one kind of capacitor (2n2F), of all capacitors on board, sometimes are open, and
Electronics Forum | Fri May 07 13:25:00 EDT 1999 | anirooth
| I would like to know if someone aleady have problems with Ceramic Capacitors SMD in In-Circuit Test (see below)and how did you solve this problems ? | | PROBLEMS | 1 - Only one kind of capacitor (2n2F), of all capacitors on board, sometimes are o
Electronics Forum | Fri May 07 15:08:51 EDT 1999 | ANIROOTH
| | I would like to know if someone aleady have problems with Ceramic Capacitors SMD in In-Circuit Test (see below)and how did you solve this problems ? | | | | PROBLEMS | | 1 - Only one kind of capacitor (2n2F), of all capacitors on board, sometim
Electronics Forum | Wed Apr 21 14:29:58 EDT 1999 | joe devaney
| Does anyone have any experience with soldering 50mil pitch BGA's that have a via in the pad, the size is .012 The via will be masked off on the bottom side of the board. Need to know what precautions or problems if any I might encounter. The proces
Electronics Forum | Tue Apr 06 16:22:58 EDT 1999 | Dave F
| 0603's and 0402's are being damaged by the water wash post reflow. PCA's are 1" X 4" and 2" X 2" approximately. | | We've adjusted water pressure so that the top-down is higher than the bottom up. | | The baskets have a .5" mesh spacing. Some
Electronics Forum | Sun Mar 21 06:27:45 EST 1999 | Bob Willis
| Hi Folks, | This is my first surface mount board, so I asked our assembly house for some tips. They said only passives on the bottom side-preferably no smaller than 0805, 0603 only if I have to. I would think that an SOT-23 would be OK on the botto