Electronics Forum | Thu May 07 11:39:29 EDT 1998 | Dave F
| Is there a machine for bending S shaped bends in leads | of through-hole components, to keep them off the surface of the board. Ryan: Some lead forming equipment can form leads to stand-off the board. Some lead forming equipment suppliers are: Au
Electronics Forum | Sat Apr 25 09:13:26 EDT 1998 | Earl Moon
| Hi, | A collegue of mine, working on incoming inspection | departement, asked me if I know any good standard,preferrable | on CD-ROM with high-quality images of different defects | that can be found on bare pcb`s. | I know IPC-standards, but i
Electronics Forum | Fri Apr 24 14:18:40 EDT 1998 | Scott Davies
I realize this is a SMT forum, but I have another problem related to electronics assembly and hope there will be someone out there that can save my life (this time). We build quite a few VME assemblies to which we attach a SAM board. Fairly standard
Electronics Forum | Mon Apr 27 06:46:39 EDT 1998 | Greg Curler
| I realize this is a SMT forum, but I have another | problem related to electronics assembly and hope there | will be someone out there that can save my life (this | time). | We build quite a few VME assemblies to which we attach | a SAM board. Fai
Electronics Forum | Sun Apr 12 12:55:11 EDT 1998 | Bob Willis
| I would like to invite everyone to share/discuss | information/knowledge/experience they have with | the req's that are assumed to be valid for the | temperature/time relation in the process of reflow | soldering Pin In Paste, Intrusive Reflow or w
Electronics Forum | Tue Apr 07 09:51:31 EDT 1998 | Gary Simbulan
Good Morning everyone. Per repeated suggestions I have been reading back issues of SMT and Circuits Assembly magazines. I have just read an article concerning selective wave soldering which I understand is to be used when active SMTcomponents are a
Electronics Forum | Thu Mar 05 16:25:27 EST 1998 | Brian Stumm @ ETS
| I am looking for information on reflow temps for a flex board. There is only one 6 pin IC but the board has a 3M double sided tape. | Is it possible to reflow without damaging the tape. Any suggestions? Do you have a profiler for your reflow oven?
Electronics Forum | Thu Mar 05 16:29:22 EST 1998 | Brian Stumm @ ETS
| Can anyone advise a good starting point for a temp profile for | on 0.05" and 1206 component boards? These boards are simple | by todays standards and do not contain any fine pitch or | other special components. | Thanks in advance... | MM Be hap
Electronics Forum | Fri Feb 20 14:33:47 EST 1998 | Dave McFadyen
Looks like (so far) we have a concensus. Follow the paste manufacturers guidelines on storage. Normally, refrigeration is required to achieve max shelf life between 3 and 6 months in original closed container. Water-wash pastes are much more active t
Electronics Forum | Fri Jan 16 23:33:32 EST 1998 | Scott
| Is there any way to implement SMT at home? | I want to assemble a prototype board of mine. | How can I hand-solder a 208-pin 0.5 mm lead | pitch PQFP -- lead-by-lead (the usual way), | or side-by-side (partial heating method)? | Alas, no SMD rework