Electronics Forum | Fri Oct 06 09:16:10 EDT 2000 | Kev Head
All, We are planning to place a daughter board that has a surface mount relay reflowed onto it already. The reason for doing this is a bit complicated and not worth noting here. The process would consist of first placing the SMT relays onto a mult
Electronics Forum | Fri Jul 14 11:34:37 EDT 2000 | Mike F
John, The first thing to check is how tight the boards are being held in the conveyor (assuming you are using a finger conveyor). They should be a little loose at the input end so there is some room to expand. If the boards are held too tightly, when
Electronics Forum | Tue Feb 29 13:18:16 EST 2000 | Steve Schrader
We have what appears to be a recurring problem. On immersion gold boards only, we are having solderability problems. After reflow, selected parts can be popped right off the board. There is then a dark haze left on the pad. The paste on the compon
Electronics Forum | Thu Feb 03 08:20:49 EST 2000 | JAX
Once you have the capabilities to track a board from the initial stages in kitting all the way out the door in box build the possibilities are endless. You will now have: 1. An exact count of your companies WIP. 2. The exact location of every board i
Electronics Forum | Tue Feb 01 12:02:56 EST 2000 | Mike Konrad
Your question may be answered in two parts. First, if you are using a water soluble (OA) paste, then water is an excellent �solvent�. Water, in one way or another, is used to clean all fluxes and pastes from PCB�s. In some cases, a chemical is add
Electronics Forum | Thu Nov 18 00:28:02 EST 1999 | Scott McKee
Use Mydata. I've built huge backplane boards, round boards, 1/4" thick boards, 1"X24" boards, 1"X1" boards, L-shapes boards; all without any carriers or tooling. If you buy a MY15 you can increase the board size to 5'X2' (60"X24")... As for ovens,
Electronics Forum | Mon Aug 23 14:13:23 EDT 1999 | C.K.
SMTnetters: Does anyone know of a place where I can have some test boards made? I don't need a board with a working circuit, traces or anything like that, but a board similar to those "test boards" that you all see at the Placement Equipment manufa
Electronics Forum | Wed Feb 03 16:45:20 EST 1999 | Mark Henebry
Does anyone know if I will have problems soldering surface mount components to an all hard gold plated PC board. We want to use hard gold similar to gold used for edge fingers because our customer is concerned about wear and conductivity of connector
Electronics Forum | Mon Oct 26 20:18:23 EST 1998 | Dave f
| I need some info on how to stop the bridges I'm having on | radial and axial parts that are in the same place on every board. I'm also having problems with sot-25 bridging. I'm using a Electrovert E-pak. I tried leveling the machine,solder pot, an
Electronics Forum | Thu Oct 01 13:31:09 EDT 1998 | FRANK
Assuming that you do not have a solderability problem with the board or part it sounds like you are not pumping the solder up high enough to contact the board plus push into the board by about 1.8mm. Are you using a chip wave in front of the normal