Electronics Forum | Thu Sep 30 15:46:22 EDT 2010 | vetteboy86
Hi Folks, I'm looking for detailed information about the different composition of circuit board pads. We have been experiencing some issues with our solder, and I would like to know the differences between compositions. I do know that we ran a cust
Electronics Forum | Thu Oct 07 15:50:57 EDT 2010 | boardhouse
Craig & Rem - I would also recomend switching to ENig - OSP would be my sencond choise ENig will give you the flatness your looking for plus the best shelf life. Enig is about 5% more than Hot Air. Enig also does not cause as much stress on the c
Electronics Forum | Wed Oct 06 22:37:48 EDT 2010 | Jacki
Dear All I need to check the solder paste volume inside the PTH at our board,which size is 440x620 mm.So, I may need 3D inspection machine,AXI, not AOI.So, does anyone recommand me which 3D machine is suited to my PCB? Thanks in advance.
Electronics Forum | Mon Oct 18 16:36:14 EDT 2010 | sbabos
Hi Jacki, My name is Sandor and we are DAGE representative in Romania. Could you please re-send me your requirement by e-mail? And I will help you to find the right loaction where you can check your board. my e-mail: sbabos@quiptech.com Thank you i
Electronics Forum | Fri Oct 15 16:52:52 EDT 2010 | wingding
Fuji IP2: I am having problems with an MTU Cycle Alarm error. There is no such error listed in the IP2 manual or the MTU manual. It sometimes comes up while placing parts on a board or sometimes right after Zero Set. Does anyone know what generates t
Electronics Forum | Tue Oct 19 08:50:30 EDT 2010 | kevinj
Hello I am looking for some help with our Siplace 80 S20. We had upgraded from the line computer to the Siplace pro and seem to be having problems with placement especially with multiple panel boards. Anyone that can help us with the software that co
Electronics Forum | Tue Oct 26 14:47:04 EDT 2010 | bwolgemuth
I'd like to know if anyone else is using this system? If so, I'd like to know the .asc format required by the machine for importing CAD and/or board data. It asks for .asc files. Programming without any data has been extremely time-consuming. Any h
Electronics Forum | Thu Oct 28 16:11:43 EDT 2010 | dwonch
Dealing with these intermittent issues can be frustrating! Can you narrow down if the defects occur during a specific time in the run? i.e. beginning or end? Or, maybe after a pause in printing such as stopping the line for lunch? Are there a lot of
Electronics Forum | Tue Nov 02 08:36:51 EDT 2010 | rgduval
Michelle, Our experience with no-clean solder pastes has been that water washing a mis-print is a bad idea. We've found that DI water does not do a sufficient job removing the no-clean paste (the same goes for stencils). Instead, we have washed no
Electronics Forum | Thu Nov 11 13:00:20 EST 2010 | 18424
Thanks Dennis, The fact that someone other than myself has experienced this is good to hear. Solder mask type should be spec'd all the same through out the many board suppliers we use but its worth the check.I have checked with kester but am still aw