Electronics Forum | Wed May 09 20:35:55 EDT 2001 | davef
Beats me. I thought you said "We are seeing a haze left behind on our current cleaners." I don't even know why you need to clean fids. [Are you scrubbing each fid to make it bright and shiney? What's on them? Why are you doing this?][I'm sorry I
Electronics Forum | Wed May 09 18:36:00 EDT 2001 | pzohbon
What are some cleaning options? Or is it a camera issue? Not all our boards need the fiducials cleaned so it is hard to tell.
Electronics Forum | Fri Oct 12 12:44:03 EDT 2001 | dalejans
Is it acceptable to clean an assembled board in the ultasonic stencil cleaner? The cleaning requirement is where water soluable flux is used and needs to be removed. Thanks for you information!
Electronics Forum | Fri Oct 19 22:55:29 EDT 2001 | ericchua
Hi, Not so sure. I know one of the equipment can do it, there is Kolb RB6D. This system can clean stencil, misprint, assembly board, etc. This Kolb also provide chemcil for the correct cleaner. Hope this can help you. Email to me if you need any he
Electronics Forum | Fri Oct 12 14:32:52 EDT 2001 | Mike Konrad
Hi, Maybe Yes� Maybe No� Actually, it most likely is acceptable to clean assembled boards in an ultrasonic cleaning system (40 kHz). There are some concerns in some circles about possible damage to wire bonds in components. There have been publi
Electronics Forum | Mon Nov 29 10:35:32 EST 1999 | Jason Birch
Gentlemen, Can anyone recommend a stencil cleaner manufacturer? Are there any advantages to using ultrasonic vs. high pressure? I am also looking to clean misprinted boards with the machine. Thanks, J. B.
Electronics Forum | Mon Oct 15 13:41:49 EDT 2001 | bschreiber
Hi Dale, I have copies of the articles of which Mike references. If you need copies for support, contact me at: bill@smartsonic.com. Rinsing should be done by ultrasonics also. Spray in atmosphere systems will not penetrate into the same tight ar
Electronics Forum | Fri Jul 23 15:47:31 EDT 1999 | C.K.
| Does anyone have any experiences with EMC stencil screen cleaners or can you recommend a good one? | SMarTsonic makes an excellent cleaner. As Bill states, it uses ultrasonics and an EPA approved detergent to wash stencils and boards. However,
Electronics Forum | Fri Jul 23 15:49:35 EDT 1999 | C.K.
| Does anyone have any experiences with EMC stencil screen cleaners or can you recommend a good one? | SMarTsonic makes an excellent cleaner. As Bill states, it uses ultrasonics and an EPA approved detergent to wash stencils and boards. However,
Electronics Forum | Fri Jul 23 16:15:30 EDT 1999 | Bill Schreiber
Dear C.K. I agree. The older style "generic" evaporators are cumbersome. However, you should checkout the new Model EZ-0 Wastewater Evaporator. It is made by Smart Sonic specifically for the SMT industry and addresses all of the maintenance relate
.gif)
.gif)
winsouce.jpg)