Electronics Forum | Wed Sep 15 06:14:16 EDT 1999 | Wayne S.
| I'm looking for some good articles on reflowing of double sided SMT boards. I'd like to come up with a process for low volume prototyping, but need to understand the do's and don'ts. | Hello, you can get some insight by typing in double sided boa
Electronics Forum | Fri Sep 10 07:43:19 EDT 1999 | Christopher Cross
| I have a board that has surface mount on both sides . On this board is a 22pin connector which is the only thru-hole part.This part is located on the component side. I would like to reflow this part. Can this be done? If so, how can this be done?
Electronics Forum | Fri Sep 10 07:45:59 EDT 1999 | Christopher Cross
| | I have a board that has surface mount on both sides . On this board is a 22pin connector which is the only thru-hole part.This part is located on the component side. I would like to reflow this part. Can this be done? If so, how can this be done?
Electronics Forum | Wed Aug 25 09:51:37 EDT 1999 | Mike F
Can anyone tell me where I can get a good lightweight material to use for a soldering fixture? I need to make various fixtures to hold LED's vertical during the soldering process, and keep them from floating up off the board surface. At a different
Electronics Forum | Wed Aug 25 10:05:56 EDT 1999 | Ray Hare
| Can anyone tell me where I can get a good lightweight material to use for a soldering fixture? I need to make various fixtures to hold LED's vertical during the soldering process, and keep them from floating up off the board surface. | | At a dif
Electronics Forum | Wed Aug 25 19:31:22 EDT 1999 | Dave F
| JUST WANDERING IF ANYONE IS PRINTING ADHESIVE ON THE BOTTOM SIDE OF BOARD WITH THROUGH HOLE COMPONENTS ALREADY PLACED. I'VE BEEN TOLD IT IS POSSIBLE BUT WANT TO LOOK INTO THIS PROCESS IN DEPTH. | Chad: You don't need to YELL!!! Anyhow, yes we ha
Electronics Forum | Mon Aug 23 20:06:49 EDT 1999 | Peter
I am looking for a source of tooling pins (various diameters) which can be easily attached (ie. taped) to pieces of FR-4 stock to allow for quick and cheap fixtures to run in my smt machines. I've seen these in the past where the pins are attached t
Electronics Forum | Mon Aug 23 20:56:29 EDT 1999 | Dave F
| I am looking for a source of tooling pins (various diameters) which can be easily attached (ie. taped) to pieces of FR-4 stock to allow for quick and cheap fixtures to run in my smt machines. I've seen these in the past where the pins are attached
Electronics Forum | Fri Jul 23 10:47:31 EDT 1999 | Mark D. Milward
There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not performing th
Electronics Forum | Wed Feb 23 11:40:38 EST 2000 | TMV
I would definitely check the amount of adhesive/paste that you are putting on the board. It may not be enough for any moving table application. If you think you are OK there, lets go on. As you probably are aware, the HSP tact times can be independan