Electronics Forum | Mon Jul 31 14:06:40 EDT 2017 | rgduval
Ain't that the truth!! In a previous life, we did a (somewhat brief) cost analysis of class three rework being performed on class two boards. When we realized how much time/money we were losing due to unnecessary rework, we decided to start taking
Electronics Forum | Tue Aug 01 11:29:02 EDT 2017 | fkn
FKN Systek makes Depanelizers that work on aluminum boards. Please call me at 508 376 2500 or send email to discuss. We usually get a customer sample just to make sure. We have been selling the K3000 and K4000 Depanelizers for over 10 years to custom
Electronics Forum | Fri Jan 05 10:58:43 EST 2018 | ilavu
John, I just found out more detail. If my board stop position in x is bigger than 109mm, I get error from park position to board stop.This problem started after power loss. The error comes up system power down and after pressing system button "RISIN
Electronics Forum | Thu Feb 01 03:02:50 EST 2018 | robl
Hi Rob, > > I did check with the board house, and > the confirmed that there was no Nickel plating, > but that the silver went straight onto the copper > in their immersion silver > process. > > Interestingly I've even tested an > unplated sam
Electronics Forum | Thu Feb 01 07:41:01 EST 2018 | dontfeedphils
Interesting, never heard of using wax as a coating mask. Not sure how well the AR coating would hold up to a hot alkaline wash (unless you have experience with it), but that stuff usually starts to flake off/de-wet if you just look at it wrong. I'm
Electronics Forum | Sat Feb 10 10:08:04 EST 2018 | griinder
We recently acquired used MPM Accuflex. Immediately I noticed the live vision is mirrored. This makes it incredibly difficult to teach fiducials. I noticed some smudges on the lens, which leads me to believe the camera assembly was "worked on" at som
Electronics Forum | Thu Feb 15 15:14:20 EST 2018 | dleeper
How are you shipping, 3rd party such as UPS, DHL, etc. Or do you have your own personnel who will be a lot more carful with the packages? I've shipped boards just in the silver ESD bags with out problems. The trick is to pack them fairly tightly so
Electronics Forum | Mon Mar 12 13:51:08 EDT 2018 | cyber_wolf
It is BS. Solder is either liquid or it isn't. Getting it hotter doesn't make it more liquid. Its very easy to prove them wrong. Have them create a profile with the bottom heater turned down. Run boards and see how many parts fall off. You create
Electronics Forum | Mon May 14 18:39:13 EDT 2018 | stephenj37824
Well we have decided to go with the Panasonic NPM W2(WX at end of year)...... Really liking the Ekra screen printers. Looking at the Serio 4000 or X5 pro large. Any recommendations for boards 24x20+? Also looking at the btu 10 zone Air 125. Cycle tim
Electronics Forum | Wed Apr 11 09:51:26 EDT 2018 | emeto
Diego, the first question you have to answer is "Is the paste volume too much in real?" How does your paste look? To check that, I would say you measure bare board with your SPI and see if your SMT pads show you zero, or may be not? If your value fo