Electronics Forum | Tue Oct 11 11:17:04 EDT 2011 | adp23
are you familiar with UL 796, Printed Wiring Boards i believe they discuss some standards and test procedures regarding conductor material, and solder material but im not sure if UL actually lists solder material by it self.
Electronics Forum | Sat Oct 22 22:10:09 EDT 2011 | unisoft
Hi maybe this will help Rich larue rlarue@unisoft-cim.com ProntoGERBER-CONNECTION ( http://www.unisoft-cim.com/gerber_connection.htm ) imports raw Gerber data and allows the user to add intelligent information to the shapes on the display and c
Electronics Forum | Sat Oct 29 14:33:34 EDT 2011 | tech1
Try swapping out the motor controller boards and see if the problem moves. More than likely it is the motor, coupling or the encoder. Some of the suggestions about reducing the acceleration in the package is a good idea but this will not provide a lo
Electronics Forum | Wed Nov 16 14:57:57 EST 2011 | austinpeterman
Hello Don, We dont heat cure any of our assemblies. We coat relitively few boards and just let them cure at room temp. Perhaps we should start heat curing. In fact, we have an old, fully functional, heller 1500 just sitting in storage. Hmmm. . .
Electronics Forum | Fri Nov 04 05:05:18 EDT 2011 | tzucury
I have a vision problem because the cam is seeing blurry, but if i manually lift the board it's starting to see more clearly, how could i fix this focus problem?
Electronics Forum | Fri Nov 04 09:29:36 EDT 2011 | remullis
You should also have a backup calibration file to reinstall. If its software related this would put everything back to spec. Mechanically I would call Mirtec as well to ask the best method so that you dont have to reteach all your boards.
Electronics Forum | Wed Nov 09 09:35:08 EST 2011 | rmitchell
Hi, I am looking for a hand print squeegee blade for proto boards and solder samples. I would like one with a handle that is fun and easy to use.
Electronics Forum | Fri Nov 11 07:48:58 EST 2011 | julien
Sure it's big enough! But unfortunately we can't go this year because we have an important customer who come at our plant at this perdiod :-( Probably next year or at SMT in nuremberg...But also it's not only defluxing oriented and only in german.
Electronics Forum | Thu Nov 10 10:15:40 EST 2011 | davef
J-STD-003 describes the test methods and gives guidelines for assessing the solderability of bare circuit boards
Electronics Forum | Fri Nov 18 14:08:44 EST 2011 | babe7362000
Is there anyone close to Ohio or in Ohio that is very familiar with the TRITON SMT IV Washer? Our tank is not staying hot to run boards thru. The temperature drops to 116. We checked all the heaters and they seem to be running fine. Any info is ap