Electronics Forum | Fri May 18 12:42:50 EDT 2018 | arachid
Hi, i search for drawing of calibration slug to calibrate a vu4/6 vision system on a quad 4c. on my manual it is name spindle runout calibration slug but not have part number. if you can give me this drawing i will very apreciate it. I need picture,
Electronics Forum | Thu Jun 12 11:04:48 EDT 2014 | bobpan
You could have a bad hard drive or the bios settings could be incorrect. We also need to find out what motherboard version you have. Please e-mail me for further help. Go to: www.precision-repairs.com and my e-mail address is on the site. Bob
Electronics Forum | Wed Jan 23 12:35:24 EST 2008 | bobpan
Here is a few things to try.... 1. Spin the z-shaft with your fingers and make sure it is smooth and easy to turn. 2. Check your handling in your profile for the part that the software is locking up on.......You cannot go any slower than 40% or this
Electronics Forum | Sun Jun 26 10:18:03 EDT 2005 | bobpan
Mike no longer is employed by Tyco. Also if i were a betting man......i would bet....that he doesnt know the quad 1000 inner workings toooo well.
Electronics Forum | Thu Jan 19 10:58:59 EST 2006 | bobpan
Doesn't Karl Mohor with KTI still service the equipment down there???
Electronics Forum | Wed Feb 23 15:07:58 EST 2005 | bobpan
Hello C.B. I am a former trainer/fse for that machine and still have a q1000 bible for fixing problems. I think the machine may need servo tuned to which there is a procedure that i would have to find. First thing to do though, is to drop the machine
Electronics Forum | Thu Jan 19 10:53:43 EST 2006 | bobpan
Walter, Read what i posted above about switching the dip switch 8 on dip 1. That will probably solve your problem but once again....make sure you write down all your machine settings because everything will be reset.
Electronics Forum | Thu Feb 02 13:20:28 EST 2006 | bobpan
shoot me a question and i will be glad to help....but you really should start a new thread....than to keep this old one going.
Electronics Forum | Mon Feb 06 20:57:51 EST 2006 | bobpan
Mazin, Give me some more information as to what originally caused the problem, Was there an electrical storm, was someone programming when the problem happened, Did you start it up and it happened, etc...etc... The more information the BETTER i can h
Electronics Forum | Tue May 31 07:04:20 EDT 2005 | bobpan
Mike, There was a dipswitch that can be changed that will clear the machine settings and reset everything back to defaults. You will also lose your programs so backing up everything is a must. If you need and/or want to do this let me know and i will
