Electronics Forum | Thu Sep 19 21:23:42 EDT 2002 | davef
I'm not saying that an eraser will necessarily work. What I'm saying is that some erasers may cause more trouble than the eliminate. Look here http://aic.stanford.edu/jaic/articles/jaic28-02-003_2.html We prefer a brand called Ruby Red. The "ole
Electronics Forum | Tue Jun 02 18:01:47 EDT 1998 | Earl Moon
| | | We have experienced poor adhesion of acrylic conformal coating to plastic bodied IC�s. The observed symptoms of this are a blistering or lifting of the coating at the surface of the component, although peel testing has revealed that this is no
Electronics Forum | Tue Nov 05 06:51:59 EST 2002 | V.RAMANAND KINI
Hi, This is a widely discussed subject and since you have asked a brief explanation, I assume, you are a business man or a top executive in the company venturing in to COB. I waited to see if someone replies to you. May be it is a very old subject
Electronics Forum | Sat Nov 14 08:05:54 EST 1998 | Earl Moon
| | | | I believe that gold fingers on my circuit boards are being | | | | contaminated and need to clean them with some chemical | | | | solution. Any recommendations. | | | | | | | Chuck: What is the type and source of your contamination? Dave
Electronics Forum | Mon Jun 23 04:00:43 EDT 2003 | Paul Cooper
Hi there There are a number of things worth considering when viewing bga's. Firstly, like any other solder joint that you have been inspecting for years, suface finish is critical. Secondly, and again like other joints shape is important. Now it may
Electronics Forum | Wed Jul 12 13:06:41 EDT 2000 | Brian W.
I have done both. If you have a line that runs both sides in none pass, running the adhesive side first allows you to have one less machine or station for board flipping. If you have to move the board from one line to another, or back to the front
Electronics Forum | Thu Feb 22 09:56:21 EST 2001 | blnorman
An adhesive, is an adhesive, is an adhesive. Yes most will thin when exposed to elevated temperature, but that's only for a short time. As cross-linking starts, viscosity increases. Having made countless numbers of adhesively bonded samples in the
Electronics Forum | Tue Aug 22 14:59:55 EDT 2000 | Mike Naddra
What does the reflow profile look like , the question I had was surrounding the higher reflow temperature and the max temperature that lowest thermal mass components will see. Some other questions that I had were surrounding the components , what of
Electronics Forum | Tue Aug 22 11:03:45 EDT 2000 | Dr. Ning-Cheng Lee
Hi Kelvin, Regarding to the surface finish of the leads, Sn or Pd may be the direction that the industry takes. First of all, the answer must be "Pb-Free", limiting our choices. Sn has good solderability, and it won't have too great of an impact o
Electronics Forum | Mon Jun 18 11:23:44 EDT 2001 | Gil Zweig
BGA defects observed with x-ray inspection fall into catagories. One catagory is the obvious defects; i.e. soledr bridges, missing balls, excessive solder voids. The second catagory is the more subtle "potential" defect. This is where variations in