Electronics Forum: booster (Page 1 of 3)

MyData A12 tool tip damage

Electronics Forum | Wed Jun 27 11:58:42 EDT 2012 | cyber_wolf

Your tool tips are being damaged because the small x-motor is not engaging when the head is picking parts. When this happens the head overshoots and you bang the tips on the mag springs. Directly after a tip gets damaged go into the service program a

Mydata TP11 1995

Electronics Forum | Thu Apr 07 07:17:54 EDT 2005 | cyber_wolf

Colin, At this point you may consider calling in Mydata. I told you the basic things I have seen cause your problems. It sounds as if you may have a bad card, and or short somewhere. Possibilities: XWB Small booster on the front of the computer bo

MyData A12 tool tip damage

Electronics Forum | Wed Jun 27 13:38:56 EDT 2012 | upguy

Thanks for the information and insights. Our booster is probably getting too hot, even with AC. There is bouncing when we trim component locations. Every so often, while trimming component locations, the x-axis will start to slowly move away (by i

MyData A12 tool tip damage

Electronics Forum | Tue Jul 17 10:47:54 EDT 2012 | upguy

As as per your information and photo, we attached two box fans under our booster and attached them to the white XGTS connector. The fans are blowing upward with airflow between the booster board and the back of the machine. We will carefully watch

Fuji versus Mydata

Electronics Forum | Fri Mar 02 16:56:37 EST 2007 | vickt

Mark, How about a "line booster" such as the Universal AdVantis AC30L? The Lightning head provides a huge boost in throughput for your existing line, while also adding to the component range. One solution is to put it in the middle of a line to retur

Mydata TP-11 Small X not working

Electronics Forum | Wed Apr 15 12:57:37 EDT 2009 | bk

I'm not sure if you fixed your problem yet or not but i'll give you some insight on your problem. The x wagon motor doesn't move cause of the voltage it actually moves when there's current applied to it. The voltage dictates the direction the motor m

Mydata TP-11 Small X not working

Electronics Forum | Wed Mar 25 14:55:17 EDT 2009 | cyber_wolf

The small x motor quit working.It seems that there is no voltage going to the motor. Here is what I have done so far: *Verified that the motor is good. *Check pico fuses on the backplane *Verify voltages on backplane and on big booster. *Swap mot ca

MyData A12 tool tip damage

Electronics Forum | Wed Jun 27 12:51:53 EDT 2012 | cyber_wolf

You can leave the booster in the original position and mount two small fans directly underneanth it blowing upward. By leaving it in the original upright position you get quite a bit of air velocity in the small space between the booster and the mach

grey appearance on solder joints after batch cleaning

Electronics Forum | Tue Feb 11 14:05:11 EST 2014 | dontfeedphils

I can't speak too much as to why your joints are appearing dull, even with the booster. I can recommend a new chemistry that Kyzen has out that I've been running for about a year now. Price is about the same, it can be run at low(er) concentrations

Mydata TP11-UFP won't initialize

Electronics Forum | Tue Jan 04 14:06:58 EST 2011 | cyber_wolf

First I would confirm that both of your X-motors and transducers are working through the service menu. After that start looking at the big power booster on the back of the machine.

  1 2 3 Next

booster searches for Companies, Equipment, Machines, Suppliers & Information