Electronics Forum: bow (Page 1 of 20)

PCB assembly bow and twist

Electronics Forum | Fri Dec 27 16:26:30 EST 2013 | davef

I expect to find the specification and measurement method for the bow & twist of an assembly to be on the assembly drawing. Comments are: * Expecting that an industry committee to write a bow & twist spec for an assembly they know nothing about is n

PCB assembly bow and twist

Electronics Forum | Thu Dec 26 12:12:55 EST 2013 | igorfo

Dear Friends, I need your help to understand requirements and measurement methods for bow and twist of assembled PCB (PCBA have and SMT and TH components). I already check all posts on the site but didn't found any related to my question answers.

Home plate or bow tie?

Electronics Forum | Sat May 27 11:13:27 EDT 2000 | Steve Thomas

Subject line pretty much says it all. We're going to try some stencil design changes to reduce midship solder balls. Anyone have some comments on pros or cons for either?

Re: Home plate or bow tie?

Electronics Forum | Sat May 27 12:50:21 EDT 2000 | Micah Newcomb

Steve, I use homebase apertures as a standard for all chip parts and have no complaints, no solder beading, no issues. I have had to replace almost all stencils ordered previous to my arrival as they all caused defects (7-9mil thickness and 1:1

Re: Home plate or bow tie?

Electronics Forum | Sun May 28 08:21:52 EDT 2000 | Sal

Can't agree more than moving over to Homebase apertures, But ensure that the cut back angle is correct,to acute of and angle will leave you with an inadequate contact area fot the terminations on the chip components and you will start seeing insuffic

Re: Home plate or bow tie?

Electronics Forum | Tue Oct 10 12:56:15 EDT 2000 | Ken Van ZIll

I agree that homplate is a good design, but also this could be caused by the stencil thickness and aperture size, if you are at 7-9 mils thick stencil and a 1:1 ratio on aperture size then 2 things i know of will happen, one a squishing out of past o

Boards Bowing

Electronics Forum | Fri Sep 30 10:13:54 EDT 2005 | Cmiller

We are having a random problem with boards bowing significantly. Its a large through hole board with only one QFP on it. The bowing occurs during the SMT reflow. The only conclusion I can come to is a problem at the board house that made it. I just w

Bow and twist of PCB's

Electronics Forum | Mon Apr 23 11:44:55 EDT 2001 | CAL

650 Standards are also located in the back of IPC JSTD-001. I am currently looking at 4 pages on bow and twist. Percent bow = R1-R2/L x 100 (R1= Highest point; R2=lowest or resting point; l= length) Percent twist=(R1-R2)/(2xL)x 100 Sorry if this is

Re: PCB warpage

Electronics Forum | Thu Oct 14 20:42:07 EDT 1999 | Jeff Ferry

Grace, As deifned in IPC 7721 Procedure 3.2 Bow and Twist Repair "Bow and twist after soldering shall not exceed 1.5% for through hole PC boards and .75% for surface mount PC boards. The bow and twist shall not be sufficient to cause difficulties d

BGA Bowing on the corners.

Electronics Forum | Fri Aug 22 09:50:20 EDT 2003 | Mike Snider

I am placing a plastic Cypress, 256 pin BGA on a small assembly, and I cannot stop the corners from bowing. I've moved my profile up and down with no results. Any suggestions?

  1 2 3 4 5 6 7 8 9 10 Next

bow searches for Companies, Equipment, Machines, Suppliers & Information