Electronics Forum | Tue May 24 18:00:42 EDT 2005 | davef
Pellet Fuels Institute; 1601 N. Kent Street, Suite 1001, Arlington, VA 22209; 703-522-6778 Fax 703-522-0548 pfimail@pelletheat.org http://www.pelletheat.org Pellet Fuels Institute represents the fuel preparation and clean burning technology of
Electronics Forum | Mon Jul 18 01:23:23 EDT 2005 | Cal
In regards to your post...I am sure Autotronk is the manufacturer. I can only asume when you speak of a "local Rep" it is in the US. If you go to Autotronik's website via the link you provided...you will see Manncorp is the Canada/USA/ Mexico Rep. He
Electronics Forum | Tue Jul 26 20:43:46 EDT 2005 | davef
And the reason the connectors aren't on one side of the board is ... Thougts are: * Pealable temporary solder mask * Removable boots Sources of boots that may be ESD protected are: * Kinnarney Rubber; 450 Main St PO Box 37 Mantua, NJ 08051; 856-468
Electronics Forum | Tue Aug 09 22:03:38 EDT 2005 | davef
Since these are mounting holes, they're probably all the same size. Why not try rubber plugs shaped like golf tees? Try: * Dempsey Industries; 802 N. 4th St, Miamisburg, Ohio 45342; (937)-866-2345; Gary Pascoe * Shercon somewhere in CA * Harman; 36
Electronics Forum | Wed Oct 19 07:30:25 EDT 2005 | davef
Try: * Electronics Manufacturing Productivity Facility (EMPF) 317.226.5640 Ray Cirimele 317.231.2045fax226.5673 * National Training Center for Microelectronics Northampton Community College 3855 Green Pond Rd Bethlehem, PA 18017-7599 610.861.4553f
Electronics Forum | Fri Jan 13 09:02:38 EST 2006 | chunks
Please, don't give em' a soap box to preach from. Now, back to No-Lead. Has anyone else out there thinking about the higher emmisions you're company will pump out due to higher temps? Just wondering. I can see the "No-Lead Brain Trust" sitting ba
Electronics Forum | Fri Jan 20 05:53:23 EST 2006 | dougs
i think it's more likely to be greasy/dirty shaft clutches, stand at the front of the machine and use the cam handle to turn the cam, while your doing this push up gently on the black top section of the shaft and try to turn the shaft, it shouldn't r
Electronics Forum | Thu Feb 16 06:37:07 EST 2006 | Mity-C
Good Morning jobbie, We have several Mydata lines. We are building low volume high mix as well. Our CPH had been identified as approximately 6000-8000 CPH depending on the application of course. We do have a separate setup area however that stages a
Electronics Forum | Wed Mar 01 07:45:56 EST 2006 | davef
Consider: * Equipment Inspection acoustic microscope [Scanning Acoustic Microscopy (SAM)] MicroPhotonics 4949 Liberty Lane, Suite 160, PO Box 3129 Allentown PA 18106 610.366.7103 fax 7105 http://www.microphotonics.com * Equipment Inspection acoustic
Electronics Forum | Tue Mar 07 15:11:43 EST 2006 | davef
We wouldn't know a Gemini from a bread box, nor we are real clear on what you seek. So, we'll just rattle on for a while. Here's how we monitor the quality of our dispensing process: * We dispense the same nonfunctional pattern of dots on every boa