Electronics Forum | Tue Dec 15 09:26:37 EST 2020 | stivais
Have you tried cutting the leads shorter (or lift the connector slightly) so that they barely protrude at the other side of the PCB? Just for testing purpose, for mass production you should find a connector with shorter leads then. This should help w
Electronics Forum | Tue Mar 23 23:17:12 EDT 2021 | llawrence
Hello everyone, I work for a company that, up until now, has done everything using through-hole components. This has been fine for years, but we have been pushed into the world of surface mount manufacturing by a new product that is far cheaper and
Electronics Forum | Thu Apr 29 06:02:35 EDT 2021 | ttheis
Buy a good used PNP machine from a dealer in your area. There is no comparison when you are using these machines for production. Unfortunately the ddm equipment you describe is unlikely to perform any better and the time you spend trying would be bet
Electronics Forum | Fri Apr 21 22:13:14 EDT 2023 | jamesatqkits
It is pretty high, I will have to try it with no exhaust, thanks for the idea. Have a great weekend. I should also mention someone that knows metal alloys told me that that much extra Nickle can cause the melt point to go up. Does anyone run hotter t
Electronics Forum | Tue May 02 14:53:31 EDT 2023 | jamesatqkits
Hi Bukas, thank you for taking the time to respond. My flow gauge shows 35 SCFH and the pressure is around 50 psi. Maybe the flow gauge is wrong? Thanks again. What delivery pressure do you run, if you run a selective solder machine? Thanks again. I
Electronics Forum | Mon Aug 14 12:06:18 EDT 2023 | calebcsmt
Please elaborate, as I have already tried to rule out printer setup. 0 contact of course, ive tried a multitude of pressures, separation speeds, cleaning frequency. Moreover, i use these settings for similar stencils and have absolutely no issue
Electronics Forum | Mon Aug 16 16:54:57 EDT 1999 | Scott Cook
| One of the DFM suggestions I've seen is to remove the solder mask web, i.e. the mask between pads on 20-mil QFP devices. The rational is that if the mask is thicker than the pad the mask can prevent the stencil from making intimate contact with th
Electronics Forum | Wed Mar 10 13:53:13 EST 1999 | Vincent Vega
| We will wave solder a board with SOIC14 and SOIC16 parts on the bottom. It has been difficult to find any specific wave solder process recommendations from manufacturers of the SOICs. The pad geometry utilizes theiving pads on both sides to reduce
Electronics Forum | Mon Feb 22 19:22:40 EST 1999 | Steve Gregory
| A rash of new products here at my company have designs with multi-pin connectors 90 out-of-phase (orientation)wiht respect to wave direction, which has lead to massive bridging (shorts) problems.... | | Does anyone still use the 45 Degree Pallet
Electronics Forum | Tue Feb 23 14:21:17 EST 1999 | Mike McMonagle
| A rash of new products here at my company have designs with multi-pin connectors 90 out-of-phase (orientation)wiht respect to wave direction, which has lead to massive bridging (shorts) problems.... | | Does anyone still use the 45 Degree Pallet