Electronics Forum | Wed Feb 12 12:06:58 EST 2003 | dwanzek
I need some input on what good solder thieves dimensions should be. I am limited to solving my bridging problem with solder thieves; all process/wave variables have been adjusted to try to solve this problem. There are several of these connectors on
Electronics Forum | Wed Feb 12 13:37:22 EST 2003 | dwanzek
I need some input on what good solder thieves dimensions should be. I am limited to solving my bridging problem with solder thieves; all process/wave variables have been adjusted to try to solve this problem. There are several of these connectors on
Electronics Forum | caldon |
Wed Jun 04 13:19:57 EDT 2003
Electronics Forum | Thu Sep 11 15:23:31 EDT 2003 | Peter L.
I have come across a rash of failed assemblies that have 0805 capacitors and resistors, bottom side glued, wave soldered and washed. Trouble shooter reported touching up the solder joints on a few areas and the boards would pass test. I had a look a
Electronics Forum | Mon Dec 08 18:52:47 EST 2003 | Craig M
Stability of process is what your measuring so lets not assume a stable process(if your process was perfect you would have no defects). With no test a medium complexity board will be around 68.7% (according to Consulogic). I dont have many other sour
Electronics Forum | Thu Apr 29 10:35:31 EDT 2004 | dougt
Start with a load cell (force sensor), you will need one that can handle the force range you will be placing. Someone please correct me on this if I'm wrong but I seem to recall that placement force runs in the range of a couple hundred grams. Chec
Electronics Forum | Sat Jul 31 23:39:53 EDT 2004 | Bryan Sherh
Dears, Is there any LGA775 socket (Tejas) in your products?or process?Here are some issues that I met in my process,need your help and hope it benefits someone. 1.Because the socket body is really very big and weighs about 37g,need special L size No
Electronics Forum | Wed Sep 15 23:15:55 EDT 2004 | pdeuel
Im with Pete, Zero defects. We have high defect rate for many reasons. No line tech, operators set up and run then when QA reports defects engneers are called. Not to make people mad but our process engneers are lacking practical experance to fix pro
Electronics Forum | Fri Nov 12 15:56:50 EST 2004 | pdeuel
Thanks, That's the direction i'm headed. After by passing relay altogeather, testing large caps for the driver supply, replacing bridge rectifiers, and the MOV's, that's about all im left with. The vacuum motor will run with the software toggle witho
Electronics Forum | Tue Jan 04 12:37:41 EST 2005 | Cmiller
We have been using this finish almost exclusively for fine pitch boards for about 5 years. Make SURE you use a board house that does the gold plating in-house. There are some potential issues as DaveF stated. The only problem we have encountered is w