Electronics Forum: brush (Page 1 of 29)

What type of brush for hand conformal coating?

Electronics Forum | Thu Dec 03 07:37:44 EST 2009 | duso02

The quality of the brush is most important. We use artist brushes from Torrington Brush Works. Sable works best but are the most expensive. We use more camel hair. They work best for us as we "hand coat" hundreds of boards a week and go through many

What type of brush for hand conformal coating?

Electronics Forum | Wed Dec 02 18:50:05 EST 2009 | smt_guy

why brush? why not spray?

What type of brush for hand conformal coating?

Electronics Forum | Thu Dec 03 08:22:18 EST 2009 | jdumont

Thanks, no ESD concerns using a non conductive brush though?

What type of brush for hand conformal coating?

Electronics Forum | Thu Dec 03 09:27:15 EST 2009 | duso02

Once you dip it in liquid, the make-up of the brush does not really matter as it is now coated. A dry brush is a different story.

What type of brush for hand conformal coating?

Electronics Forum | Wed Dec 02 14:54:52 EST 2009 | jdumont

Hi all, just wondering what type of brushes you all are using to manually touch up/apply your conformal coatings? We use an solvent based acrylic and do minor touch ups as they are processed. Occasionally we will have a bristle or two come off the

What type of brush for hand conformal coating?

Electronics Forum | Thu Dec 03 07:09:59 EST 2009 | jdumont

We spray with an Asymtek C-740 system. However, some very small PCBs we do by hand and we also touch up after a PCB has to be repaired.

Coating Brush Touch-up

Electronics Forum | Thu Dec 04 12:24:35 EST 2008 | jdumont

We have the same Asymtek machine, same Humiseal product, same bubbling issue on touch ups. Ive found that very light pressure and a thinner mixture usually yields good results for us. Generally I dip the brush in the mixture and let it drip near wher

feedback error on CSM84

Electronics Forum | Thu Dec 14 23:21:12 EST 2017 | jmelson

OK, I think you are right! The one brush I can get to looks fine, the other one is on the back, and there's no way to get to it without removing the motor. Even the front brush was VERY hard to get back in. But, there are rubber plugs that allow y

kapton dots and liquid solder mask

Electronics Forum | Thu Aug 18 13:11:39 EDT 2005 | jsloot

We have our board house apply a peel coat mask that can be brushed off after wave or reflow. You need to brush off while it's still warm.

Mydata M12 issue

Electronics Forum | Tue Oct 27 12:23:44 EDT 2009 | cyber_wolf

One thing a lot of people don't know is that the small X motor on MY machines have carbon brushes in them. If you do not replace the brushes before they wear out it trashes the motor.

  1 2 3 4 5 6 7 8 9 10 Next

brush searches for Companies, Equipment, Machines, Suppliers & Information

Online IPC Training & Certification

Inspection mirrors for electronic rework and repair.
Fluid Dispense Pump Integration

Best Reflow Oven
IPC Training & Certification - Blackfox

Repair tools for all your electronic circuit board repair needs.
Accurate and consistent volumetric Dispensing System Solutions for 1- and 2-component fluids with ASYMTEK Vortik family of pumps. Learn more.

回流焊炉