Electronics Forum | Mon Apr 24 14:04:44 EDT 2006 | pjc
You did not tell us where your boards fit on the thermal mass range. That is key. I've run Pb Free low to medium thermal mass boards with good results on a 5 zone oven (5 top/5 bottom). You should not have a problem running a medium thermal mass boa
Electronics Forum | Sat Apr 10 08:17:21 EDT 2010 | nagesh
Dear All, I have a problem with the BTU-paragon -150 reflow oven,with the heaters getting off with Overtemperature Alaram. But the actual temperature on board not exceeding the 255 peak temp. Pls. advice & thx in advance for your sincere postings. R
Electronics Forum | Wed Nov 29 23:25:23 EST 2006 | fastek
Is this a recent happening or has it always occured since you got the oven?
Electronics Forum | Thu Nov 30 12:30:59 EST 2006 | cyber_wolf
Increase your PM frequency........???
Electronics Forum | Mon Apr 12 12:01:27 EDT 2010 | tommyttr
One of the air temp sensors by the blower is bad. Unplug them and check each to find the defective one.
Electronics Forum | Thu Nov 12 06:38:00 EST 2009 | nagesh
Dear All, I have a problem with the BTU-Paragon 150 10 Zone Reflow Oven. Am not able to lift the HOOD using the buttons on the Main control panel. I have checked the Lift hood switch & Ok. Pls. advice / Suggest. Thx in advance for all your sincere
Electronics Forum | Wed Nov 18 13:00:16 EST 2009 | evertonsanches
Dear All, > > I have a problem with the > BTU-Paragon 150 10 Zone Reflow Oven. Am not able > to lift the HOOD using the buttons on the Main > control panel. I have checked the Lift hood > switch & Ok. Pls. advice / Suggest. > > Thx in > advanc
Electronics Forum | Thu May 30 09:41:30 EDT 2013 | giangi
Hello, I have 4 BTU Paragon 150s in the factory where I work for. One of them has a weird behaviour: in order to get the same thermal profile as for the other ovens, I have to increase a lot all the temperatures. I think there is something wrong with
Electronics Forum | Mon Jun 03 16:52:22 EDT 2013 | smellew
Hi Yes, there is an FCU calibration procedure which may help you, for this information please contact us direct. Email llew@SurfaceMountEngineering.com Web: http://www.SurfaceMountEngineering.com Fuji, DEK, BTU, Ersa & Vi Technical support & service
Electronics Forum | Thu Nov 30 10:38:39 EST 2006 | billwestiet
You are cooling too fast, and some flux and paste is worse than others... Can you control your cooling zones? Water Temp (higher)? Or Water Flow (less, effectively less cooling)? Changing water temp is prefferable over flow if you can do it. I h