Electronics Forum | Fri May 15 21:39:48 EDT 2015 | jlawson
Reflow.. 1.Rehm (Germany) - Best in Class Best overall process stability heating system ( Alot of makers have started to copy there VX heating arrangement ). COnveyor chains can be a bit more attention in terms of maintenance on rehm , but if foll
Electronics Forum | Mon Apr 09 11:39:32 EDT 2018 | emeto
The easiest way to do without special tools is to use level. Check machine co-planarity on the conveyor rails in both directions(you can do that with rails down or rails up or both). Then check co-planarity on the stencil. If the level shows the sam
Electronics Forum | Tue Apr 20 11:25:59 EDT 2010 | cunningham
Has anyone got any of these ovens or know of any issues with these? We are on the market for a 10 or 12 zone oven and the BTU above is looking like the favourite Any info would be great
Electronics Forum | Wed Nov 18 14:42:22 EST 1998 | Dave F
| I heard somewhere that SMEMA has joined IPC, and that the association has decided to boycott Nepcon from | year 2000. Can anyone tell me if this is true | Nick: SMEMA and IPC are talking about merging (EP&P, 11/98, p 18). Below is a news release
Electronics Forum | Wed Apr 21 14:32:52 EDT 2010 | remullis
These ovens maintain good profiling as long as you stay on top of maintenance. I had 4 150's and 1 125. The biggest headache is keep the plenums cleaned (very messy). Also the blower motors have been replaced a few times on them as well. If I were yo
Electronics Forum | Fri May 15 14:50:40 EDT 2015 | emeto
My top 3 printers: 1.DEK 2.MPM 3.EKRA Top 3 ovens: 1. BTU 2. Vitronics 3. Heller or Electrovert
Electronics Forum | Tue Mar 30 06:27:22 EDT 2010 | ristikas
It happens on the middle of the stecil cleaning. The camera and the cleaner will stay under stencil in half way back. Then machine asking the initate the motors. If to press initate then the pcb stopper will hit the rails. Usually we move camera and
Electronics Forum | Fri Jul 12 12:30:56 EDT 2002 | soupatech
I just go off the phone w/ Fuji and they seem to think that the lizard tounge (used another name, same idea) is only available for the IP3. They had a few other suggestions for adapting the IP2 like a rubber pad for the carrier or building "rails" to
Electronics Forum | Sat Feb 12 13:19:27 EST 2011 | tpappano
A simple trick I read either here or on another P&P forum is to use "Silly Putty". Place a small thin spot of Silly Putty on the top of the front conveyor rail, and put the machine in "manual" mode. Steer head #1 over the putty and lower it, leavin
Electronics Forum | Fri May 15 12:41:48 EDT 2015 | deanm
I chose a Vitronics XPM3i primarily for the AutoSet automatic profile generation feature. We are high mix and simply cannot profile every board. The AutoSet feature is quick, easy and we rely on it 100% and have great results. These ovens have had ve
