Electronics Forum | Tue Mar 30 14:59:00 EST 2004 | Claude_Couture
no help from BTU, didn't buy from them so no support. I found the cause of the problem. The input of the controler relating to the conveyor alarm must have been stuck. By toggling the trigger value from Lo to High in the setup screen, I caused an ala
Electronics Forum | Mon Apr 12 09:13:45 EDT 2010 | toddl
Check your "over temperature module" for both top and bottom zones when the alarm is active, there is a bank of LED's on the bottom of this module. Monitor it to find out if the same zone keeps activating the alarm, if so check your TC for that zone.
Electronics Forum | Mon Dec 17 12:12:18 EST 2007 | Claude_Couture
in very rare occasion I had problems with BTU ovens, I contacted BTU directly and they were always helpful.
Electronics Forum | Tue Jun 04 11:17:39 EDT 2019 | dman97
Does anyone have a manual for a BTU PYRAMAX 150N X5 oven? We recently got one of these used and it has the flux management system attached along with a water chiller. We hooked everything up, but the oven throws a water supply problem alarm. Chill
Electronics Forum | Mon Dec 25 12:17:57 EST 2006 | KEN
first, does the recipe have the heat and conveyor boxes checked? If no then it does nothing. second, have you pressed the round green switch? third, are there any alarms in the alarm box? Do you have a controller link fail? Verify the cable is p
Electronics Forum | Sun Apr 23 09:07:42 EDT 2006 | kanna
i have one problem here with BTU TRS-14. we encounter Over temperature Alarm trigger when run lead free product. our profiling peak temp is 230 degree's and the temperature set point at zone 4 top/bottom is 260 degree's. can any help on this issue
Electronics Forum | Sun Apr 23 09:04:36 EDT 2006 | kanna
Does anyone have any experience with these ovens > ? We are looking at purchasing a used > one. Anything in particular I should look at > when inspecting it ? > > Any comments good or bad > appreciated..... > > Thnx, Sr. i have one problem he
Electronics Forum | Fri Oct 28 13:58:57 EDT 2016 | ttheis
Hi everyone, We just picked up an old VIP70 oven and it is in need of more maintenance than we were told when we bought it so I'm working on a few issues. The main thing right now is linking the FCU controller to the PC. I've tried using both seria
Electronics Forum | Thu Apr 07 10:39:36 EDT 2005 | geb
I have a BTU International VIP98 reflow oven, running WINCON Version 2.00C on Windows 98. The light tower only lights green when the oven reaches temperature, and the other colours never light up. Do you know how to set the other colour lights to tu
Electronics Forum | Mon Oct 01 19:44:49 EDT 2007 | marcelll
Just bought a used VIP 98 and I have an alarm. Computer don't communicate with the embedded controler of the oven. I've check the cabling, OK, and there's power on the controler. The PC is booting normally. The controler is plug in the serial port 2
winsouce.jpg)
