Electronics Forum: btu paragon 150 (Page 1 of 8)

BTU -Paragon 150

Electronics Forum | Sat Apr 10 08:17:21 EDT 2010 | nagesh

Dear All, I have a problem with the BTU-paragon -150 reflow oven,with the heaters getting off with Overtemperature Alaram. But the actual temperature on board not exceeding the 255 peak temp. Pls. advice & thx in advance for your sincere postings. R

BTU -Paragon 150

Electronics Forum | Mon Apr 12 12:01:27 EDT 2010 | tommyttr

One of the air temp sensors by the blower is bad. Unplug them and check each to find the defective one.

BTU -Paragon 150

Electronics Forum | Thu Nov 12 06:38:00 EST 2009 | nagesh

Dear All, I have a problem with the BTU-Paragon 150 10 Zone Reflow Oven. Am not able to lift the HOOD using the buttons on the Main control panel. I have checked the Lift hood switch & Ok. Pls. advice / Suggest. Thx in advance for all your sincere

BTU -Paragon 150

Electronics Forum | Wed Nov 18 13:00:16 EST 2009 | evertonsanches

Dear All, > > I have a problem with the > BTU-Paragon 150 10 Zone Reflow Oven. Am not able > to lift the HOOD using the buttons on the Main > control panel. I have checked the Lift hood > switch & Ok. Pls. advice / Suggest. > > Thx in > advanc

BTU Paragon 150

Electronics Forum | Thu May 30 09:41:30 EDT 2013 | giangi

Hello, I have 4 BTU Paragon 150s in the factory where I work for. One of them has a weird behaviour: in order to get the same thermal profile as for the other ovens, I have to increase a lot all the temperatures. I think there is something wrong with

BTU -Paragon 150

Electronics Forum | Wed Nov 18 12:56:06 EST 2009 | evertonsanches

Hello I had similar problem on VIP 70A. Try to check auxiliar contact from located into front panel. Everton - BRAZIL

BTU -Paragon 150

Electronics Forum | Mon Apr 12 09:13:45 EDT 2010 | toddl

Check your "over temperature module" for both top and bottom zones when the alarm is active, there is a bank of LED's on the bottom of this module. Monitor it to find out if the same zone keeps activating the alarm, if so check your TC for that zone.

BTU Paragon 150

Electronics Forum | Mon Jun 03 16:52:22 EDT 2013 | smellew

Hi Yes, there is an FCU calibration procedure which may help you, for this information please contact us direct. Email llew@SurfaceMountEngineering.com Web: http://www.SurfaceMountEngineering.com Fuji, DEK, BTU, Ersa & Vi Technical support & service

BTU Paragon 150 Reflow Oven

Electronics Forum | Mon Sep 19 17:21:14 EDT 2005 | rick

They're full of crap and are simply trying to get you into a Paramax 150. Depending on your product you could probably get by with a VIP-98.

BTU Paragon 150 Reflow Oven

Electronics Forum | Thu Sep 15 13:32:04 EDT 2005 | cyber_wolf

Does anyone have any experience with these ovens ? We are looking at purchasing a used one. Anything in particular I should look at when inspecting it ? Any comments good or bad appreciated..... Thnx, Sr.

  1 2 3 4 5 6 7 8 Next

btu paragon 150 searches for Companies, Equipment, Machines, Suppliers & Information