Electronics Forum | Tue Jun 04 11:17:39 EDT 2019 | dman97
Does anyone have a manual for a BTU PYRAMAX 150N X5 oven? We recently got one of these used and it has the flux management system attached along with a water chiller. We hooked everything up, but the oven throws a water supply problem alarm. Chill
Electronics Forum | Fri May 24 08:46:07 EDT 2024 | baronfferzog
Have you tried cannacraftcorner asking your paste supplier about pureplantpleasures this issue?
Electronics Forum | Fri Aug 11 00:51:41 EDT 2023 | ttheis
Have you tried asking your paste supplier about this issue?
Electronics Forum | Tue Apr 20 11:25:59 EDT 2010 | cunningham
Has anyone got any of these ovens or know of any issues with these? We are on the market for a 10 or 12 zone oven and the BTU above is looking like the favourite Any info would be great
Electronics Forum | Thu Aug 08 01:13:46 EDT 2019 | ameenullakhan
Thanks a lot everyone. For the valuable knowledge sharing. And technical links. ( will go through it ) We have BTU oven ( Pyramax X 150N ). Regards, Ameen
Electronics Forum | Fri Aug 11 00:53:33 EDT 2023 | thecolonel97
I actually just sent an email today to our paste provider ECO Solder/Senju to get their input as well.
Electronics Forum | Wed Aug 23 14:58:38 EDT 2023 | markhoch
I was at our local SMTA Michigan Chapter Tech Forum & Tabletop Expo last week and BTU was introducing a new option designed to reduce flux build-up in the heating zones. Might not be a bad idea to reach out to them to learn more about it. Just a sug
Electronics Forum | Mon Aug 25 02:57:43 EDT 2014 | arjunkolavara
We are in the process of qualifying our SMT lines for the High Melting Point Solder with alloy composition of 93.5 Pb 5 Sn 1.5 Ag.If any one has already an experience with this alloy,kindly do give ur inputs on the process of profiling . The reflow d
Electronics Forum | Tue Aug 22 15:22:46 EDT 2023 | thecolonel97
Our paste manufacturer failed to respond. I did try adding 2 frozen jugs of water into the reservoir tank, this did not lower the cooler 1 temp. We have to have a water or air flow restriction causing this to run hotter. Still currently investigat
Electronics Forum | Wed Apr 21 14:32:52 EDT 2010 | remullis
These ovens maintain good profiling as long as you stay on top of maintenance. I had 4 150's and 1 125. The biggest headache is keep the plenums cleaned (very messy). Also the blower motors have been replaced a few times on them as well. If I were yo
