Electronics Forum | Fri Jul 30 10:30:23 EDT 1999 | Wolfgang Busko
| | | While inspecting incoming PCBs we detected around all plated-through-holes (only there and all in the same place) some halfmoonshaped light rings that match obviously only with the pink ring symptom shown in the IPC-A-600 chapter 2.5.2.. That w
Electronics Forum | Fri Jul 30 16:06:22 EDT 1999 | Earl Moon
| | | | While inspecting incoming PCBs we detected around all plated-through-holes (only there and all in the same place) some halfmoonshaped light rings that match obviously only with the pink ring symptom shown in the IPC-A-600 chapter 2.5.2.. That
Electronics Forum | Sat Jul 17 13:25:02 EDT 1999 | Scott
| | | | | | I need a good chemical to remove the lacquer finish off of magnet wire. I know there are different kinds but I need one that really works. Any suggestions would be great. thanks in advance guys. | | | | | | | | | | | What is it you're tr
Electronics Forum | Fri Jun 18 14:28:14 EDT 1999 | Scott Cook
| | Now don't everyone jump on this at once, but it seems time for me to send out copies of my not even close to being dated copy of an article about HASL. Though it was published in 1992, in Printed Circuit Fabrication Magazine, and it got rave revi
Electronics Forum | Tue Jun 08 17:52:53 EDT 1999 | Chrys Shea
| | | Hi,my master | | | How to iron out such soldering bridge with below conditions: | | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | | 3.using s
Electronics Forum | Wed Jun 02 15:11:56 EDT 1999 | MD Cox
| | ok, ok, so I'm not an engineer. I'm a salesguy ( and that's nothing to be ashamed of...) Here's my dilemma. I represent a contract manufacturer who is in the early stages of quoting on "turnkey" assembling of a circuit board for a manufacture
Electronics Forum | Fri Jun 04 06:58:59 EDT 1999 | S. Kopetzky
| | | ok, ok, so I'm not an engineer. I'm a salesguy ( and that's nothing to be ashamed of...) Here's my dilemma. I represent a contract manufacturer who is in the early stages of quoting on "turnkey" assembling of a circuit board for a manufactu
Electronics Forum | Sun May 30 18:34:04 EDT 1999 | Earl Moon
| | | | | | Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but accord
Electronics Forum | Tue Apr 27 17:34:52 EDT 1999 | Jeff Sanchez
| | As I transfer prototypes/pilots out of my shop (because the designs are mature or Engineering confidence is high). How do I minimize my risk and ensure success for both the CEM and my boards. | | | | Best Regardsgroup. This would include low t
Electronics Forum | Wed Apr 28 14:32:36 EDT 1999 | JohnW
| | | Thank for the input. But I guess I was looking for more. We have been transferring boards for some time and a have good working relationship with our primary CEM and have worked out many bugs. I was thinking more on the order and don't shoot
