Electronics Forum | Wed Jun 01 22:42:50 EDT 2016 | dinhhuunam
CAN Node Not Responding This problem can be caused by either: 1. Faulty Node 2. CAN bus cable disconnected. 3. No power to CAN Node.
Electronics Forum | Fri Aug 26 05:18:05 EDT 2016 | ariss_t
Hi, anybody facing the vision 'off' error when using MPM Momentum ?? i change the purple vision cable but still facing the same issue.. the image go black when camera moving for searching fiducial.. any ideas ??
Electronics Forum | Tue Apr 25 17:09:02 EDT 2017 | tomwd
Is the computer PSU located in BM4CB unit and get the 12v/5v voltages generated from 12v/5v box via the XP5/12v cable?
Electronics Forum | Tue May 02 22:04:54 EDT 2017 | ttheis
Have you reviewed the wiring diagrams and checked voltages at the input card? Maybe you have a damaged IO card or broken cable.
Electronics Forum | Tue Dec 05 02:15:12 EST 2017 | bukas
is that the only motor with that function or there are others? if you have more than one motor try switching cables and/or drivers and see what happens. this kind of behavior can also be caused by stepper driver.
Electronics Forum | Tue Jan 09 15:26:49 EST 2018 | emeto
The truth is that TH will give you better mechanical stability. If it is a part where you risk strip off the pads of SMT connector, don't make this transition to SMT. If it is a one time cable plug there and there will be not too much pressure, go fo
Electronics Forum | Mon Mar 05 11:12:13 EST 2018 | assuredtech
Without a known good Executive and a known good battery and a known good Comm cable, card swapping / exchange is probably not going to be helpful yet. I might have an Executive you can try, I'll try sending you an e-mail.
Electronics Forum | Thu May 17 06:46:39 EDT 2018 | godless
After fresh install and loading only machinekey + stdeaf files it worked, thanks. But still there is camera problem which appeared from the beginning. I attached files where you can see error details. Software reinstallation not solved issue. Then ca
Electronics Forum | Mon Jul 30 17:31:59 EDT 2018 | dekhead
That error message is keyed by a hardware (soldered) link on the backplane board of the Y1 (motor controls), through direct cable to PCIB40#3... check connections both ehds; possibility of multiple PCIB failures?
Electronics Forum | Tue Jul 31 17:24:33 EDT 2018 | erici
There is a hardware dongle at the back of the machine. Is this the hardware link (key) you are referring to? Ok i will check the cables to PCIB40#3. Thanks again
