Electronics Forum | Thu May 22 08:15:15 EDT 2003 | mario1304
First of all thanks to everyone who has replied, especially Pete C for his long article :-). My question is, do you have any special software to collect all the needed data? Cause data isn�t equal to information , i guess a "stupid database" (and a h
Electronics Forum | Sat May 31 14:33:59 EDT 2003 | kenBliss
CAL Here is another perspective. Ask what is included in the setup costs, ie. programming, stencils, setting up part number bins, bill of materials, changeover time on the line etc, etc. Then ask how much time and costs the CM is allowing for each
Electronics Forum | Wed Jun 11 22:56:10 EDT 2003 | jgregory
OK Terrapin, Here it is, roughly half hour after I vented on your reply. I still don't like your attitude to "school" me on this subject. I've been doing this way too long. But I decided that I would satisfy your attempt at "learnin" me. First, I
Electronics Forum | Thu Jun 12 14:49:33 EDT 2003 | bubbacott
Jason I am an equipment buyer part of my job is to be knowlegable in every make and model we look at, registration is a calculable cost going in before penny one is spent many brokers and oem's know who I am and I will rage about registration, howeve
Electronics Forum | Fri Jun 13 22:04:47 EDT 2003 | iman
I would say, if one guy buys used machine from a "dealer", the dealer ought to cover the registration fee up-front for the buyer as part of a complete package, UNLESS the buyer himself/herself asked for a discount that purposefully omitted the requi
Electronics Forum | Wed Mar 03 13:33:25 EST 2004 | stefwitt
How well should the fiducial be centered in the teach mode? Consider that you see the fiducial with probably 40 times magnification on the monitor. If you see the cross-hair a bit off center, then this is most likely just by a few hundreds of a milli
Electronics Forum | Tue Jul 13 16:19:05 EDT 2004 | Inspection Solution
Hi Mark, There are many tools available for measuring solder paste height. Most machines use laser as the basis for inspection while others use structured white light. If simple height and width inspection is all that is required, you can look int
Electronics Forum | Fri Nov 12 15:56:50 EST 2004 | pdeuel
Thanks, That's the direction i'm headed. After by passing relay altogeather, testing large caps for the driver supply, replacing bridge rectifiers, and the MOV's, that's about all im left with. The vacuum motor will run with the software toggle witho
Electronics Forum | Wed Nov 16 10:48:23 EST 2005 | aj
Hi, There are a few different types of CP6 which I think the main differences are on the board loading side of things. To briefly answer your questions: 1.What is the actual CPH you are getting during production. There are a lot of variables to c
Electronics Forum | Thu Nov 17 23:33:08 EST 2005 | darby
If the machine is on it's way..... Question is 1. What if the machine is on its way / remote site...and need to estimate (say 90-95%) probability ? A1. 1 x 8 hour shift 65% x 1 of software estimate or stop watch estimate run on same machine in a dr