Electronics Forum | Wed May 18 18:36:22 EDT 2005 | global
Ok here's one for ya. We have a DEK 260 with a Cyberbectic vision system, 1 of about only 50 made as told to me by a DEK service Tech. So if anyone has operated one of the other 49 you may be able to help. The Service techs at DEK are not familiar en
Electronics Forum | Mon Jun 13 11:48:33 EDT 2005 | CMiller
We got a F04 error (internal Memory fault) on the shared drive and entered 8 in location N001 as per the maint manual and cycled the power. I then set all the locations listed in the manual to thier default settings. Now the motors do not run to thei
Electronics Forum | Thu Jul 21 14:05:19 EDT 2005 | cyber_wolf
Dave, I think I worded my post poorly. I am not sure if "tuning fork type" is the correct terminology. The instrument I am looking for usually has a hand held unit connected to a device that resembles a small tuning fork. As a matter of fact, I thi
Electronics Forum | Thu Sep 01 08:15:51 EDT 2005 | jdengler
The 1CA0A009 would lead me to believe that the PD's may not be as accurate as possible. If the PD is bad then every location that uses that PD will have about the same error rate. The 12040403 would lead me to believe the feeders are haveing trouble.
Electronics Forum | Fri Sep 23 04:12:11 EDT 2005 | siverts
Installation/set up of the component shuttle is critical. The shuttle must be perfectly squared and leveled, since it has a 4 spindle pick/place head on it. This shuttle head can pick up to 4 comps. from the shuttle feeders (gang pick) and will deliv
Electronics Forum | Fri Sep 23 08:27:28 EDT 2005 | siverts
The 7 spindle Flex jet head, can only pick max 7 comps. from the GSM base machine in a single operation, not from the shuttle. The Flex jet head is faster in z-axis and will also use the OTHC (On The Head Camera) to inspect most of Your smaller comps
Electronics Forum | Sun Oct 30 03:55:43 EST 2005 | mika
I apologize for my poor english. First: "Double sided sticky tape" is excellent for various reasons; right/left?. Second: NPI? Don't hesitate, If You feel that a certain machine in Your line cofiguration don't place certain/certain's components on th
Electronics Forum | Tue Nov 29 16:30:05 EST 2005 | russ
We have utilized one of these for about 6mos. now (is that right Larry? I know you're reading this.) So far it has proven to be a very good machine. Getting the vision right on chip caps can be tricky and sometimes frustrating but once they are rig
Electronics Forum | Fri Jan 06 16:14:10 EST 2006 | trynders
Have had a lot of issues with our machine and was just curious if anyone else out there was having any problems with theirs. This is actully our second 3Z. Our first one had so many problems Contact took it back and replaced it with a newer one. Abou
Electronics Forum | Fri Jan 13 10:39:53 EST 2006 | samir
Good one! I remember at my old company, the auditors, both internal and external would go immediately to the refrigerator where we kept our glue and solder paste and then they would spend most of their time there, because they were afraid of all of
