Electronics Forum | Tue May 10 09:45:53 EDT 2011 | veeckm
After changing mod codes 50,51 and 54,55 respectively on the HHT I will then goto ccconfig.sys file in the central controller software and manually enter in the new mod code values. I do not do any uploading/downloading of mod codes through database
Electronics Forum | Fri May 06 09:33:22 EDT 2011 | jimlas53
RLM, you have been very helpful! Let me try this on you: We have two IVC's, one with a conveyor and Quadalign, the other with a workholder platform and Cyber-optic. I just ran the first successful assembly on this second system, but the extents had
Electronics Forum | Tue Jun 28 20:35:16 EDT 2011 | smellew
Hi you can buy the motors individually direct from Siemens or others suppliers like ourselves SME(Surface Mount Engineering)also many other uk & EU dealers(STM, Adopt, AMS,ISS & CPS, just search you'll find them plus many china suppliers, (Left side
Electronics Forum | Mon Aug 08 16:14:36 EDT 2011 | wmburke
We are building a plasma diagnostic to monitor MHD phenomena in tokamak. As part of the development, we need high-voltage, high-power RF capacitors to tune and match an inductive load. This application is similar to a small induction heater, with t
Electronics Forum | Tue Sep 13 11:05:38 EDT 2011 | nucleartoast
I worked for Electrovert for 20 years as a machine designer. Our first computer controlled solder machine the Century 2000 used Infra red pyrometers that were very accurate - once you calibrated it against what you wanted to measure. So the aim and s
Electronics Forum | Thu Aug 16 12:46:47 EDT 2012 | derekj
Thank you for your reply Bob. 1. It appears the machine is picking the part up, hovering over the board and rejecting it. So it's not blowing the parts out of the pocket. Turning the vv off still results in the same issue. 2. All the tolerances are
Electronics Forum | Tue Oct 09 11:42:42 EDT 2012 | cyber_wolf
Actually the correct way to fix this is to carefully remove the belt on the rear of the machine that connects the left and right rail lead screws together. Square the rails then carefully re-install the belt *without turning either of the lead screws
Electronics Forum | Thu Feb 14 17:36:28 EST 2013 | dontfeedphils
I'm trying to get an '07 Accuflex into production and I seem to have a small problem. When trying to calibrate the zero pressure point on the squeegees I drive them down until they are touching the stencil and once they touch the stencil they run ou
Electronics Forum | Tue Jul 23 13:36:52 EDT 2013 | jsmorse
Does anyone have info on the "Cycle Steel" function on the Fuji XP141 machines. I am new to the industry and have not had any luck finding information on it. I talked to Fuji and they just tell me to leave it on, it will help with placement. We hav
Electronics Forum | Thu Aug 01 16:28:17 EDT 2013 | jimmyboz
Does anyone have info on the "Cycle Steel" > function on the Fuji XP141 machines. I am new to > the industry and have not had any luck finding > information on it. I talked to Fuji and they > just tell me to leave it on, it will help with > pl