Electronics Forum | Tue Feb 03 02:55:04 EST 2015 | max83
Hi, > > We have a snap-off issue. I guess it can > be linked to z calibration. > Hi, > > We have a snap-off issue. I guess it can > be linked to z calibration. > Hi, > > We have a snap-off issue. I guess it can > be linked to z calibration.
Electronics Forum | Mon Sep 05 11:51:30 EDT 2022 | jojoled
Can anybody help with Re-calibrating the Z-axis height in MS parameter , on JUKI KE760L? In MS parameter manual, there is information that these accessories are needed to recalibrate the Z-axis , can anybody tell where to get them, or ideally how to
Electronics Forum | Thu Sep 14 06:18:00 EDT 2023 | deniseburton
Hello, mcdvoice It seems like your Juki RS-1R machine's laser height calibration may be off. When measuring a 0402 resistor, it consistently reports heights around -0.60 to -0.70, causing pickup issues during production. Manually adjusting it to -
Electronics Forum | Wed Feb 07 12:56:00 EST 2001 | jax
I' ll have to agree with Dave on this one. Just get the information from the Suppliers. The Glass plate, Aluminum board, Glass slugs, etc... are all used to determine if a calibration is needed or if it was succesful.( they can also give you offset i
Electronics Forum | Fri Apr 05 17:46:06 EST 2002 | franciscoioc
I own 3 CS-600 locator machines and need to calibrate one of them but I don't have the calibration grid.I contacted CONTACT SYSTEMS the manufacturer and they said they don't support this machines any more. Does any one have a calibration grid for thi
Electronics Forum | Fri Jan 02 05:40:20 EST 2004 | p.LAKSHMANAN
cALIBRATION OF SOLDERING IRON DEPENDS ON THE USAGE AND AGAIN DEPENDS ON THE PERFORMANCE.NORMALLY U CAN FIX THE CALIBRATION INTERVAL AS 3 MONTHS (OR) 6 MONTHS AND ANALYSE IF THERE IS ANY SUBSTANTIAL DRIFT IN THE READINGS(BETWEEN ACTUAL AND DISPLAYED).
Electronics Forum | Wed Dec 14 15:49:30 EST 2005 | derengmao
I did calibration for the fixed camera according to the Training Center System's book. But it seemed it is for diciding the heads'offset, very few is for camera itself. When calibrate, It does recognize the calibration tool ad finish. However when te
Electronics Forum | Sun Jan 29 11:59:13 EST 2006 | johnw
Hi Better to check the table calibration and wedges also the rack and pinion gear at the back of the table for control if you go into mechacheck you can set the servo and the calibration data if its an early cp6 its quite simple to set up if its a cp
Electronics Forum | Fri Feb 10 12:28:05 EST 2006 | jdengler
We do the same as SR Tech but add in a check of the thermocouples the oven uses to monitor it's own temp. Annually I attach a thermocouple from a calibrated thermometer to the thermocouple in the oven. I compare the readings. We specify a plus min
Electronics Forum | Mon Feb 13 07:44:12 EST 2006 | Chunks
That's why I parallel ported the T/C's. Now I can use a calibrated hand help thermocouple and plug into the T/Cs on the oven. If they're within about 3 degrees of each other, then they're considered within our specification. Paper work on the hand
