Electronics Forum | Thu Aug 16 12:46:47 EDT 2012 | derekj
Thank you for your reply Bob. 1. It appears the machine is picking the part up, hovering over the board and rejecting it. So it's not blowing the parts out of the pocket. Turning the vv off still results in the same issue. 2. All the tolerances are
Electronics Forum | Tue Oct 09 11:42:42 EDT 2012 | cyber_wolf
Actually the correct way to fix this is to carefully remove the belt on the rear of the machine that connects the left and right rail lead screws together. Square the rails then carefully re-install the belt *without turning either of the lead screws
Electronics Forum | Thu Feb 14 17:36:28 EST 2013 | dontfeedphils
I'm trying to get an '07 Accuflex into production and I seem to have a small problem. When trying to calibrate the zero pressure point on the squeegees I drive them down until they are touching the stencil and once they touch the stencil they run ou
Electronics Forum | Tue Jul 23 13:36:52 EDT 2013 | jsmorse
Does anyone have info on the "Cycle Steel" function on the Fuji XP141 machines. I am new to the industry and have not had any luck finding information on it. I talked to Fuji and they just tell me to leave it on, it will help with placement. We hav
Electronics Forum | Thu Aug 01 16:28:17 EDT 2013 | jimmyboz
Does anyone have info on the "Cycle Steel" > function on the Fuji XP141 machines. I am new to > the industry and have not had any luck finding > information on it. I talked to Fuji and they > just tell me to leave it on, it will help with > pl
Electronics Forum | Thu Jan 16 22:59:04 EST 2014 | comatose
As far as OEMs go, Universal themselves are pretty reasonable about second-user support. Its only $500 to register an older GSM, and their factory field service people aren't any more expensive than many competent smaller companies. You do have to bu
Electronics Forum | Fri Jan 31 11:45:52 EST 2014 | emeto
Hi, to get better image you will probably need higher voltage(depending on how close you want to look). The closer you get the higher the voltage should be. Here are some tips for machine calibration: 1. Make sure your board is on focus. I don't kn
Electronics Forum | Tue Mar 04 17:17:29 EST 2014 | catsem23
Hi I'm trying to pick and place a lot of sod523 components with a mydata my12. I'm using C14 standard tool and Hydra tool H01. For some reason no matter what I try to do when the head picks the component with the C14 tool the machine emergency stops
Electronics Forum | Thu May 01 19:11:15 EDT 2014 | bobpan
As a small business owner and former FSE...Every customer is different. I can tell you that i talk to the customer and before i travel i will ask them....Do i need to bring my basic set of tools or can you supply basic tools. If not this saves the cu
Electronics Forum | Wed Dec 10 16:14:37 EST 2014 | jimpat
The 300 degrees is the temperature as measured at the sensor. The actual air temperature just above your PCB may actually be much less. If the oven is properly calibrated then the 300 should represent air temperature at the board but I have seen ma
